GE DNCK440GAWC Bruksanvisning

GE Torktumlare DNCK440GAWC

Läs nedan 📖 manual på svenska för GE DNCK440GAWC (3 sidor) i kategorin Torktumlare. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/3
GE Appliances
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
Dryer Dimensions (in inches)
Exhaust Options:
Electric: 4-way via rear, right, left and bottom. Maximum recommended exhaust duct length
is 45 feet of 4” rigid ducting with two 90° elbows and a 4” dampered wall cap.
Gas: When viewed from the front of the unit, exhaust 3-way via rear, left and bottom.
Maximum recommended exhaust duct length is 15 feet of 4 rigid ducting with two 90” °
elbows and a 4 dampered wall cap.”
Circuit Requirements:
An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a
time-delay fuse, is required.
Electric Dryer Rating:
208/240V, 5600W, 24A, 60Hz
208V, 4400W, 22A, 60Hz
A special 208 volt heater, part # WE11X0101 is avaialable to reduce drying time in
208 volt installations.
Gas Circuit Requirements: An individual branch circuit fused for 15- or 20-amp is required
for each dryer.
Gas Dryer Rating: 115V; 60Hz
Gas (BTU/Hr): 22000. Factory equipped for natural gas. tested for LP gas. A conversion Kit is
required for LP gas.
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
Installation Information: For complete information, see installation instructions packed
with your dryer.
36 42
27
23-1/2
2-1/2
25-1/2*
Side View Rear View
5-1/4
25-3/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
GE Appliances
Specification Revised 2/02
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
Features and Benefits
•Super 7.0 Cu. Ft. Capacity
•3 Dry Cycles: High Heat; Medium Heat; Low Heat
•4 Heat Selections
•Cool Down (with High Heat Cycle)
•ESD Smart Card Reader with Alphanumeric Display and Control Card
• Digital Cycle Countdown with LED Indicators
•Quiet Package
• Lockable Lint Filter
• Reversable Door Swing
• DuraDrum™Interior
• Model DNCK440EAWC–White
• Model DNCK440GAWC–White
GE Appliances
Specification Revised 2/02
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
Dryer Exhausting Information Use Metal Duct Only—For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4 diameter all rigid metal exhaust duct. If ” “all rigid metal”
duct cannot be used, then flexible all metal“ ” venting can be used, but it will reduce the maximum recommended
duct length.
Exhaust Length Calculation:
1. Determine the number of 90°turns needed for your installation. If you exhaust to the side
or bottom of dryer, add one turn.
2. The maximum length of 4 rigid (aluminum or galvanized) duct which can be tolerated is shown ’
in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45°or less may be ignored. Two 45 elbow. A°turns within the duct length should be treated as a 90°
turn over 45 should be treated as a 90° ° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and
lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard
or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall
cap must also be located at least 12 above the ground or any other obstruction with the opening pointed Down.”
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4 opening”
dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
Special Installation Requirements
Alcove or Closet Installation:
•If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
•The dryer MUST be exhausted to the outside.
•Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0” either side
3” front and rear
• ” Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52 .
•Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area
equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.
of open area equally distributed.
•The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
•No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
•The dryer MUST be exhausted to the outdoors.
•The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI
Z223.
Minimum Clearances other than Alcove or Closet Installation:
•Minimum clearances to combustible surfaces
0” both sides
3” rear
R
Listed by
Underwriters
Laboratories
4
B
2-1/2
A
0 90 ft. 60 ft. 55 ft. 45 ft.
1 60 ft. 45 ft. 40 ft. 30 ft.
Super & Extra-Large 2 45 ft. 35 ft. 30 ft. 20 ft.
6.0 Capacity Models 3 35 ft. 25 ft. 20 ft. 15 ft.
All Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.
0 45 ft. 30 ft. 30 ft. 15 ft.
Super & Extra-Large 1 35 ft. 20 ft. 20 ft. 10 ft.
6.0 Capacity Models 2 25 ft. 10 ft. 10 ft. —
All Gas Dryers 3 15 ft. — — —
0 60 ft. 48 ft. 30 ft. 18 ft.
1 52 ft. 40 ft. 22 ft. 14 ft.
Extra-Large 5.7 2 44 ft. 32 ft. 14 ft. 10 ft.
Capacity Electric 3 32 ft. 24 ft. — —
and Gas Dryers 4 28 ft. 16 ft. — —
Number
of
90°
Turns
Maximum Length of 4"
Dia. Rigid Metal Duct
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type Exhaust Hood Type
Domestic
Dryer Models
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
B
2-1/2"
Opening
Best Performance
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.

Produktspecifikationer

Varumärke: GE
Kategori: Torktumlare
Modell: DNCK440GAWC

Behöver du hjälp?

Om du behöver hjälp med GE DNCK440GAWC ställ en fråga nedan och andra användare kommer att svara dig


Torktumlare GE Manualer

GE

GE GTD33EASKWW Bruksanvisning

1 Mars 2025
GE

GE HTX26EASWWW Bruksanvisning

31 Januari 2025
GE

GE DDG9580R Bruksanvisning

31 Januari 2025
GE

GE GFDS170 Bruksanvisning

31 Januari 2025
GE

GE GTX33 Bruksanvisning

31 Januari 2025
GE

GE GFD40ESCMWW Bruksanvisning

17 December 2024
GE

GE SBSD137HMS Bruksanvisning

8 December 2024
GE

GE FPDW1 Bruksanvisning

8 December 2024
GE

GE GFD55ESSN0WW Wasdror Bruksanvisning

21 Oktober 2024
GE

GE GTDL210ED0WW Wasdror Bruksanvisning

20 Oktober 2024

Torktumlare Manualer

Nyaste Torktumlare Manualer

Zanussi

Zanussi ZTA 245 Bruksanvisning

9 April 2025
Bauknecht

Bauknecht TKL M11 72 Bruksanvisning

9 April 2025
Amana

Amana NGD4600YQ Bruksanvisning

9 April 2025
Whirlpool

Whirlpool awz 9479 Bruksanvisning

9 April 2025
AEG

AEG 65770IH3 Bruksanvisning

7 April 2025
Arcelik

Arcelik 901 KMP IG Bruksanvisning

7 April 2025
Arcelik

Arcelik 901 KMP I Bruksanvisning

7 April 2025
Miele

Miele METEOR 285C Bruksanvisning

6 April 2025
Miele Professional

Miele Professional PT 8203 SL WP Bruksanvisning

6 April 2025
Asko

Asko tc 741 Bruksanvisning

6 April 2025