GE Profile JD900CKCC Bruksanvisning

GE Ugn Profile JD900CKCC

Läs gratis den bruksanvisning för GE Profile JD900CKCC (16 sidor) i kategorin Ugn. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 3.5 recensioner. Har du en fråga om GE Profile JD900CKCC eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/16
1
Before You Begin
Read these instructions carefully and completely.
IMPORTANT—Save these
instructions for local inspectors use.
IMPORTANT—Observe all
governing codes and ordinances.
Note to Installer—Be sure to leave these
instructions with the consumer.
Note to Consumer—Keep these
instructions for future reference.
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under the warranty.
NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric drop-in ranges must be hard
wired (direct wired) into an approved
junction box. A plug and receptacle is NOT
permitted on these products.
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Self-Cleaning Radiant
Electric Drop-In Range
Installation
Instructions JDP47, JD968, JD900
Materials Needed
Junction Box Wire NutsStrain Relief Clamp
for 1/2 conduit
Parts Included
Lower Trim
2 Screws
2 Shoulder Screws
(for stop device)
Tools You Will Need
1/8 Drill Bit and
Electric or Hand Drill
Phillips Screwdriver
Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Standard Screwdriver
Pencil
Safety Glasses
Hammer
31-10622-1 1-07 JR


Produktspecifikationer

Varumärke: GE
Kategori: Ugn
Modell: Profile JD900CKCC

Behöver du hjälp?

Om du behöver hjälp med GE Profile JD900CKCC ställ en fråga nedan och andra användare kommer att svara dig