Havis C-3090-4 Bruksanvisning
Sidor 4 Engelska Bilsats
Läs bruksanvisningen för Havis C-3090-4 gratis online eller ladda ner PDF:en. Bruksanvisningen har visats 24 gånger. Fråga om modellen? Ställ en fråga
INSTALLATION INSTRUCTIONS C-3090’s & C-3089’s
COMPUTER LAPTOP MOUNT AND ACCESSORIES
TOOLS NEEDED:
Ratcheting wrench
Standard socket set
Open-end wrench set
Allen wrench set
Screwdriver set
Always!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
1.MOUNTING C-3090-3 or 4 & C-3089-3 or 4 to C-TCB’S
Photo #3 on page #2 is a basic assembly
instruction of a C-3090-3 (w/ tilt/swivel)
mounting to a C-TCB-x.
The tilt/swivel assembly, (Photo #1), which
comes pre-assembled to the C-3090 from the
factory, will bolt directly to the rotating plate,
using the hardware loosely attached to the
plate. You do not need to unassembled the
tilt/swivel from the C-3090.
Note: Be sure the 2” fender washer is assembled between
the rotating plate and the tilt/swivel assembly.
2. C-3090-1 or 2 & C-3089-1 or 2 MOUNTING TO
VEHICLE TUNNEL PLATES:
The C-3090 will come pre-assembled with
tilt/swivel attached.
Mount trak kit into vehicle.
Place console and C-3090 into desired
position on trak. (Photo #2)
Note: Be sure assembly does not interfere with dash or
console.
Slide ¼-20 hex nuts into slots on side of trak
in location to mount C-3090.
Attach C-3090 to trak using ¼-20 x ½” hex
bolts and washers. Tighten in desired area.
Photo #1
Photo #2
Produktspecifikationer
| Varumärke: | Havis |
| Kategori: | Bilsats |
| Modell: | C-3090-4 |
Behöver du hjälp?
Om du behöver hjälp med Havis C-3090-4 ställ en fråga nedan och andra användare kommer att svara dig