Honeywell CT50 Bruksanvisning


Läs gratis den bruksanvisning för Honeywell CT50 (16 sidor) i kategorin Termostat. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 3.5 recensioner. Har du en fråga om Honeywell CT50 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/16
CT50 Series
Thermostat
Getting started
Before you begin, make sure you have:
No. 2 Phillips & small pocket screwdrivers
• Hammer
Level (optional)
• Pencil
Drill and bit (3/16 for drywall, 7/32” for plaster)
® U.S. Registered Trademark. Patents pending.
Copyright © 2006 Honeywell International Inc.
All rights reserved.
Owner’s Manual
English: Page 1
Mode d’emploi
Français: Page 6
Manual de Uso
Español:gina 11
Check package contents:
• Thermostat
Wall anchors & screws (2 each)
Wire labels
Remove your old thermostat
Old thermostat
Leave wallplate in place Is there a sealed tube containing mercury?
If so, see mercury notice below.
Cover
MERCURY NOTICE: If your old thermostat contains mercury, contact your local waste
management authority for proper disposal instructions.
CT50K (24 Vac heating systems) CT53K (750 mV or 12Vdc heating systems)
TURN OFF POWER at heating/cooling system (or fuse/circuit-breaker panel).
Remove cover and thermostat, but leave wallplate with wires attached.


Produktspecifikationer

Varumärke: Honeywell
Kategori: Termostat
Modell: CT50

Behöver du hjälp?

Om du behöver hjälp med Honeywell CT50 ställ en fråga nedan och andra användare kommer att svara dig