Hudson Valley Arietta 6500-AGB Bruksanvisning

Hudson Valley Lättnad Arietta 6500-AGB

Läs gratis den bruksanvisning för Hudson Valley Arietta 6500-AGB (2 sidor) i kategorin Lättnad. Guiden har ansetts hjälpsam av 16 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 8.5 recensioner. Har du en fråga om Hudson Valley Arietta 6500-AGB eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/2

6500

Thank you for purchasing our lighting fixture.

Please clean with a soft, dry cloth ONLY! Do not

use cleansers.

www.hudsonvalleylighting.com

GENERAL

1. To ensure successful installation, the following instructions and agram(s) should di

be read and understood.

2. All electrical connections must be made in accordance with the National Electric

code and local codes and ordinances. If you are uncertain how to install electrical

wiring and lighting fixtures, secure the services of a qualified licensed electrician.

TOOLS NEEDED

Blade screwdriver, phillips screwdriver, slip joint pliers or small adjustable wrench,

wire cutter/stripper, electrical current tester, stepladder and electrical tape.

INSTALLATION PREPARATION

1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH

THE LIGHTING FIXTURE IS TO BE ATTACHED. Turn circuit breaker

to the off position or completely remove the fuse controlling the circuit.

2. If an existing fixture is being replaced, remove it and note to which of the

wires in the outlet box the fixture was attached. DO NOT SEPARATE

MULTIPLE TWISTED WIRES THAT MAY BE IN THE BOX. DO

NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular

circumstances the BLACK wire will be the “Hot” lead and the WHITE wire will

be the “Neutral” or “Common” lead. A GREEN or BARE COPPER wire is the

“Ground”. In older buildings it is always good practice to reconfirm the polarity

of the wiring.

3. This fixture is designed to be mounted on an octagon box. The box must be

securely mounted to the structure of the building.

FIXTURE INSTALLATION

1.Remove the fixture and parts bag(s) from the carton. Before discarding the

carton, double check packing to make certain that all parts are found.

2. Attach the mounting bar to the outlet box. (The green screw should face out).

Pull wires out of box. Thread the nipple onto the mounting bar.

3. Fasten the bare ground wire to the green or bare copper wire in the outlet box

or the green screw on the crossbar.

NEVER FASTEN THE GROUND WIRE TO THE BLACK OR "HOT"

WIRE ! FAILURE TO FOLLOW THIS INSTRUCTION COULD

RESULT IN SERIOUS INJURY OR DEATH !

4. Fasten the fixture lead with the ridge(s) to the white wire in the outlet box.

Fasten the wires together with an approved fastener (wire nut) arting about 1" St

below the fastener, tightly wrap the connetion with electrical tape so that the tape

seals the end of the fastener. Make sure that there is no exposed wire or

strands that could cause a dangerous short circuit !

5. Connect the black fixture wires to the black wire in the outlet box. Fasten the

joined wires as in step 4.

6 Place the canopy over the outlet box and fasten it by the ball nut. .

7. Install the lamp, The fixture is rated for 60 watt type C lamp.

DO NOT EXCEED RECOMMENDED WATTAGE !

8. Restore power to circuit at breaker or fuse box.

NOTE: The important safeguards and instructions outlined on this sheet are not

meant to cover all possible conditions and situations that may occur. It must be

understood that common sense, caution and care are factors that cannot be built

into any product. Caution and care must be supplied by the person(s) installing,

operating and maintaining this lighting fixture.

Produktspecifikationer

Varumärke:	Hudson Valley
Kategori:	Lättnad
Modell:	Arietta 6500-AGB
Sladdlängd:	1.2 m
Anslutningsteknik:	Bedraad
Maximal upplösning:	2048 x 1536 Pixels
Medföljande kablar:	KVM
Hörlursutgångar:	1
Mått (B x D x H):	154 x 65 x 27 mm
Antal mikrofoningångar:	1
Antal portar:	2
Tangentbordsanslutning:	USB
Musanslutning:	USB
Antal datorer:	2
Ljudanslutningar:	Ja