Hudson Valley Newport 6513-AGB Bruksanvisning
Hudson Valley
Lättnad
Newport 6513-AGB
Läs gratis den bruksanvisning för Hudson Valley Newport 6513-AGB (2 sidor) i kategorin Lättnad. Guiden har ansetts hjälpsam av 21 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 11 recensioner. Har du en fråga om Hudson Valley Newport 6513-AGB eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
6510, 6513, 6515
Thank you for purchasing our lighting fixture.
Please clean with a soft, dry cloth ONLY! Do not
use cleansers.
www.hudsonvalleylighting.com
GENERAL
1. To ensure successful installation, the following instructions and diagram(s) should
be read and understood.
2. All electrical connections must be made in accordance with the National Electric
code and local codes and ordinances. If you are uncertain how to install electrical
wiring and lighting fixtures, secure the services of a qualified licensed electrician.
TOOLS NEEDED
Blade screwdriver, phillips screwdriver, slip joint pliers or small adjustable wrench,
wire cutter/stripper, electrical current tester, stepladder and electrical tape.
I NSTALLATION PREPARATION
1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING
FIXTURE IS TO BE ATTACHED. Move the appropriate circuit breaker to the “off
position or completely remove the fuse controlling the circuit.
2. If an existing fixture is being replaced, remove it and note to which of the wires
in the outlet box the fixture was attached. DO NOT SEPARATE ANY OTHER
WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF
OLDER WIRING. In regular circumstances the BLACK wire will be the “Hot” lead
and the WHITE wire will be the “Neutral” or “Common” lead. A GREEN or BARE
COPPER wire is the “Ground”. In older buildings it is always good practice to
reconfirm the polarity of the wiring.
3. This fixture is designed to be mounted on a standard round or octagon box. The
box must be securely mounted to the structure of the building.
NOTE: This fixture is approved for ceiling installation on an outlet box containing
leads suitable for 90 Degree Celsius (C). Most dwellings built before 1985 have a
wire temperature rating of 60 Degrees Celsius (C).
FIXTURE INSTALLATION
1. Remove the fixture, shades and parts bag(s) from the carton. Before discarding
the carton, double-check packing to make certain that all parts are found.
2. Install crossbar onto junction (outlet) box as shown with screws provided.
3. Start nipple into crossbar, as shown.
4. Fasten the green fixture wire to the green or bare copper wire in the box or
fasten it to the crossbar with green screw provided.
NEVER FASTEN GROUND WIRE TO THE BLACK OR “HOT” WIRE! THE
FAILURE TO FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS
INJURY OR DEATH!
5
. Fasten the white fixture wire to the white wire in the outlet box. Fasten the wires
together with an approved fastener (wire nut). ting about 1” below the fastener, Star
tightly wrap connection with electrical tape so that the tape seals the end of the
fastener. Make sure that there is no exposed wire or strands that could
cause a dangerous short circuit !
6. Connect the black fixture wires to the black wire in the outlet box.
Fasten the joined wires as in step 5.
7.
Slip the fixture pan over the nipple in the crossbar. Secure the fixture pan to the
outlet box with washer and hex nut provided so that the fixture pan is held secure
to the ceiling.
8. Install lamps (light bulb) in fixture. This fixture is rated for A type lamps 0 watt 6
maximum. DO NOT EXCEED RECOMMENDED WATTAGE!
9. Install glass into trim ring. This trim ring is designed to aid in the easy installation
of the glass. The inside of the trim ring has three cap nut protrusions which are to
be positioned inside the keyhole slots on fixture pan. Turn trim ring with glass
counterclockwise to secure to fixture pan.
10. Restore power to circuit at breaker or fuse box.
NOTE: The important safeguards and instructions outlined on this sheet are not
meant to cover all possible conditions and situations that may occur. It must be
understood that common sense, caution and care are factors that cannot be built
into any product. Cautio d care must be supplied by the n an person(s) installing,
operating and maintaining this lighting fixture.
Produktspecifikationer
| Varumärke: | Hudson Valley |
| Kategori: | Lättnad |
| Modell: | Newport 6513-AGB |
Behöver du hjälp?
Om du behöver hjälp med Hudson Valley Newport 6513-AGB ställ en fråga nedan och andra användare kommer att svara dig
Lättnad Hudson Valley Manualer
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
5 Januari 2025
Lättnad Manualer
- Casalux
- KlikaanKlikuit
- Karwei
- Crestron
- Maxim
- Friedland
- Knog
- Rayzr 7
- BeamZ
- Gira
- Toolcraft
- Elation
- EtiamPro
- EMOS
- Sencys
Nyaste Lättnad Manualer
9 April 2025
9 April 2025
9 April 2025
8 April 2025
8 April 2025
8 April 2025
7 April 2025
5 April 2025
5 April 2025
5 April 2025