Infinity Prelude MTS Stand Bruksanvisning
Läs gratis den bruksanvisning för Infinity Prelude MTS Stand (4 sidor) i kategorin högtalare. Guiden har ansetts hjälpsam av 4 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 2.5 recensioner. Har du en fråga om Infinity Prelude MTS Stand eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Installation Guide
Floor Stand for Prelude MTS Tower
PRELUDE
™
MTS-STAND
2
PRELUDE MTS-STAND
Installing the Tower onto the Floor Stand
–When using the tower as a surround speaker,
set Toggle Switch in tower cup to “Full Range.”When using as
a front channel,set Toggle Switch in tower cup in bottom to
the “Full Range”position.Please consult the Prelude MTS
Subwoofer manual for exceptions to this setting.
S 1TEP
– Insert double-ended Audio Banana Plug into tower
as shown.
S 3TEP
– Screw alignment pins into cup in bottom of tower.
Use two per tower. Screw threaded ends into holes and tighten
until snug.DO NOT overtighten.
–To add greater stability to the tower stand,add
sand (not included) in the plastic bag provided in the tower base.
Turn the base upside-down and remove the (3) 1/4-20 Phillips
screws holding the foot onto the base.
S 4TEP
S 2TEP
3
PRELUDE MTS-STAND
– Remove one foam pad,pull out the plastic bag and open
it.Place it back into the opening of the base,taking care to fold it ove r
the sides so as to keep sand from falling into the base. Fill the plastic
b ag with sand.
S 5TEP
– Seal the plastic bag,making sure to tuck it back
inside the base and place the previously removed foam pad on
top of the sealed bag.Replace the foot with the same 1/4-20
Phillips screws.
S 6TEP
–Turn stand over and slowly lower the tower
assembly onto the stand,being careful to insert the alignment
pins into their receptacle guide holes.
S 7TEP
– Fasten the four
10-32 Socket Head Screws
through the tower base as
shown;two through the front
bae and two in the rear slot.
Press ush into place two
screw caps to hide holes in
front-bae base. Make sure
that the alignment slots point
toward the center to ensure that
the surface curve matches that
of the bae.
S 8TEP
Produktspecifikationer
| Varumärke: | Infinity |
| Kategori: | högtalare |
| Modell: | Prelude MTS Stand |
Behöver du hjälp?
Om du behöver hjälp med Infinity Prelude MTS Stand ställ en fråga nedan och andra användare kommer att svara dig
högtalare Infinity Manualer
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
högtalare Manualer
- Posh
- SoundBot
- Vimar
- Zolid
- JAZ Audio
- Anker
- Cerwin-Vega
- Conceptronic
- Wavemaster
- Blackstar
- Ices Electronics
- Omnitronic
- Stereoboomm
- Lenovo
- Antec
Nyaste högtalare Manualer
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025