Joy-it SBC-PoE-Power Bruksanvisning
Joy-it
Inte kategoriserad
SBC-PoE-Power
Läs gratis den bruksanvisning för Joy-it SBC-PoE-Power (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 6 recensioner. Har du en fråga om Joy-it SBC-PoE-Power eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
ISOLATED POWER-OVER-ETHERNET
SPLITTER
SBC-PoE-Power & SBC-PoE-Power-C
Joy-IT powered by SIMAC Electronics GmbH - Pascalstr. 8 - 47506 Neukirchen-Vluyn - www.joy-it.net
1. General Information
2. Requirements
3. Connection & Usage
4. Information & take-back obligations
5. Support
TABLE OF CONTENTS
Dear Customer,
thank you for choosing our product. In the following, we will guide you
through what to pay attention to during commissioning and use.
If you encounter any unexpected problems during use, please feel free to
contact us.
To be able to draw power via the network connection, additional power
must be fed into the network line. This can be realized, for example, via a
Power Over Ethernet network switch or an injector. These devices feed the
power into the network line themselves.
Now connect the PoE splitter to your network cable, which is connected
to your router or a switch in your network. The network connector, as well
as the Micro-USB or USB-C output (depending on the version of your PoE
splitter), can now be connected to your end device.
Please note that the splitter outputs a voltage of 5V and is suitable for
an output current of up to 2A. Before use, make sure that your device is
compatible with these values.
1. GENERAL INFORMATION
2. REQUIREMENTS
3. CONNECTION & USAGE
Attention! The device is suitable for network speeds up to 100 Mbps. For
higher network speeds, you must limit the speed of your Raspberry Pi to
100 Mbps using the following command:
sudo nano ▬etc▬rc1local
sudo nano ▬etc▬rc1local
sudo nano ▬etc▬rc1local
sudo nano ▬etc▬rc1localsudo nano ▬etc▬rc1local
Insert the following line before the line with the content 'exit 0':
sudo ▬sbin▬ethtool ‘s ethө advertise өxөөӏ ӧ
sudo ▬sbin▬ethtool ‘s ethө advertise өxөөӏ ӧ
sudo ▬sbin▬ethtool ‘s ethө advertise өxөөӏ ӧ
sudo ▬sbin▬ethtool ‘s ethө advertise өxөөӏ ӧsudo ▬sbin▬ethtool ‘s ethө advertise өxөөӏ ӧ
Produktspecifikationer
| Varumärke: | Joy-it |
| Kategori: | Inte kategoriserad |
| Modell: | SBC-PoE-Power |
Behöver du hjälp?
Om du behöver hjälp med Joy-it SBC-PoE-Power ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Joy-it Manualer
8 April 2025
8 April 2025
31 Januari 2025
29 Januari 2025
29 Januari 2025
15 Januari 2025
2 Januari 2025
28 December 2024
5 December 2024
5 December 2024
Inte kategoriserad Manualer
- Physa
- UTEPO
- Koss
- Apollo Design
- Contour
- Electrify
- Panta
- Elite Force
- Thule
- Festo
- Black Box
- Knog
- MXL
- Nibe
- Invacare
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025