Joy-it SEN-Pressure10 Bruksanvisning
Joy-it
Inte kategoriserad
SEN-Pressure10
Läs gratis den bruksanvisning för Joy-it SEN-Pressure10 (8 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 16 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 8.5 recensioner. Har du en fråga om Joy-it SEN-Pressure10 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8

SEN PRESSURE-
Thin Film Pressure Sensor
Joy IT powered by SIMAC Electronics GmbH Pascalstr. 8 47506 Neukirchen Vluyn www.joy it.net- - - - - -

1. GENERAL INFORMATION
Dear customer,
thank you very much for choosing our product.
In the following, we will introduce you to what to observe while starting
up and using this product.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
2. DIFFERENCES BETWEEN THE 3 DIFFERENT SENSORS
The diagram on the le shows the pressure resistance relationship for -
the entire resistance range.

The right diagram is a partial section of the le diagram and shows the
pressure resistance relationship normalized for resistance values up to -
30 kΩ.
The actual data should be tested aer installation. All data without
guarantee!
3. DETECTION OF THE SUPPORT SURFACE WITH WHICH MEASURE-
MENT IS CARRIED OUT
Important with this sensor is that you can only measure with a certain
part of the sensor. The part which is used here for measuring is outlined
in red in the figure below. This part is only 7.5 x 7.5 mm in size.
The following formula is used to calculate the voltage from the measured
values:
The above formula is composed of the , the supply voltage (VCC) known
resistor value from the above diagram (RC) known resistance and the
value on the PCB of the sensor (510 kΩ).
4. CONNECT TO THE RASPBERRY PI
First connect the module to your Raspberry Pi.
This pressure sensor is an analog sensor.
Since the Raspberry Pi has no analog inputs, you have to use an
analog digital converter. In this example we use the ADC -to-COM KY053-
from .Joy-IT
Produktspecifikationer
Varumärke: | Joy-it |
Kategori: | Inte kategoriserad |
Modell: | SEN-Pressure10 |
Behöver du hjälp?
Om du behöver hjälp med Joy-it SEN-Pressure10 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Joy-it Manualer
8 April 2025
8 April 2025
31 Januari 2025
29 Januari 2025
29 Januari 2025
15 Januari 2025
2 Januari 2025
28 December 2024
5 December 2024
5 December 2024
Inte kategoriserad Manualer
- Infinity
- Avanti
- Berker
- Emmaljunga
- VAVA
- Storm
- Club 3D
- Kopp
- Favero
- MBZ
- Aston Microphones
- Iomega
- Datacolor
- Datacard
- Lantus
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025