Klein Tools VDV826-602 Bruksanvisning


Läs gratis den bruksanvisning för Klein Tools VDV826-602 (6 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 10.5 recensioner. Har du en fråga om Klein Tools VDV826-602 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/6
Recommended Care and Maintenance of Klein
®
Grips
WARNINGS:
For use by properly trained professionals
ONLY
.
Grips are to be used for temporary installation,
NOT
When used on or near energized lines - ground, insulate, or isolate grip before pulling.
Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
Always match proper grip to application.
DO NOT
exceed rated capacity.
SELECTION:
Three factors are used to select the proper grip application:
1. Type of wire or cable.
2. Outside diameter of wire or cable.
3. Maximum safe load required.
Tools to assist with in proper selection:
1. See our interactive Grip Selection Guide.
2. Contact your local Klein Tools Distributor.
3. Call Klein Tools at or 1-844-395-3235 1-800-KLEIN76.
OSHA INFORMATION:
OSHA requires that all hand tools and equipment be maintained in good working order
and that they be free from damage caused by wear or abuse (OSHA Part 1910, Subpart
P, Section 1910.242). In addition, OSHA Part 1926, Subpart V, Section 1926.955,
paragraphs (C) (7) (ii) and (C) (8) specifically state that:The manufacturer’s load
rating shall not be exceeded for stringing lines, pulling lines, sock connections, and all
load-bearing hardware and accessories.” “Conductor grips shall not be used on wire rope
unless designed for this application.
See back for cleaning, lubricating and inspection instructions.


Produktspecifikationer

Varumärke: Klein Tools
Kategori: ej kategoriserat
Modell: VDV826-602

Behöver du hjälp?

Om du behöver hjälp med Klein Tools VDV826-602 ställ en fråga nedan och andra användare kommer att svara dig