Kohler Freewill K-12208 Bruksanvisning

Läs gratis den bruksanvisning för Kohler Freewill K-12208 (24 sidor) i kategorin dusch huvud. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 7 recensioner. Har du en fråga om Kohler Freewill K-12208 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

1011310-2-B

2002 Kohler Co.

Español, Página 17

Français, Page 9



FREEWILL BARRIER-FREE

MULTI-PIECE SHOWER MODULES

K-12200, K-12201, K-12207,

K-12208

BEFORE YOU BEGIN

PREPARATION

Install the unit to a level subfloor.

Provide properly dimensioned framing.

Insulate all exterior walls before installation.

The basin area requires no additional support

when the subfloor is plumb and level with respect

to the stud frame. Shim as needed to level the

module.

For optimum accessibility, specify faucets and

fittings to install and operate within the control area

shown in the roughing-in diagrams.

ACCESS REQUIREMENTS

Be sure you have enough access to move the

module into the construction area.

One-piece shower modules are too large to fit

through standard door openings. Therefore, this

multi-piece module is designed to be separated

into sections for moving into the installation area.

Once near the installation area, reassemble the

module and move it within the installation area.

TRANSPORTATION/PROTECTION

Protect the floor of the module during installation.

When moving the module, avoid flexing the side

walls to prevent radius cracking.

Until you are ready to begin the actual installation,

leave the packaging material in place to prevent

damage. Protect the module from damage.

Protect the module from damage after installation.

CODE CONSIDERATIONS

When fire-rated wall is specified, the stud opening

dimensions are to the inside of the wallboard.

If the module is to be installed adjacent to vertical

ducts or chases, fire-rated wallboard should

surround the module.

OTHER PLUMBING CONCERNS

Before beginning, consult all applicable

instructions included with options and accessories.

In locations where plumbing is adjacent to a

masonry wall, make provisions for access to the

connections. Construct a separate wall at least 6”

(15.2cm) from the masonry wall. Install furring

when the back of the unit is against the masonry

wall.

Connect the valve to the water supplies, and check

for leaks before installing the module.

Locate the rough plumbing for the drain in

accordance with the roughing-in dimensions.

Position the plumbing as required by the

manufacturer’s instructions.

Before installation, provide access to all

connections. Because the module must be

installed as an assembled “one-piece” module, the

drain and overflow connections cannot be made by

reaching over the end of the module.

Produktspecifikationer