Kuzco Vega LP18248 Bruksanvisning

Läs gratis den bruksanvisning för Kuzco Vega LP18248 (1 sidor) i kategorin Lampa. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 9 recensioner. Har du en fråga om Kuzco Vega LP18248 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

INSTALLATION SHEET

LP18248

LED Linear Pendant

START FROM HERE

1. Remove fixture from its original package

2. Pull magnetic plate off bottom of (2a)

canopy (1c) to gain access

3. Attach canopy to electrical junction (1c)

box (1a)(1d) using screws provided in

hardware package

4. To change fixture height, push and hold wire

gripper (2g), slide wire to desired length and

then release wire gripper to secure (2g)

5. Make proper electrical connections (black to

hot “L”, white to neutral “N”, ground to

“GND”) with wire nuts provided in (1b)

hardware package

6. Remove tape off the driver and insert (1f)

driver inside canopy (1c)

7. Close canopy by re-attach magnetic (1c)

plate (2a), make sure no electrical wires or

support cables are in the way

1a.

1c.

1b.

1d.

2a.

1e.

1f.

2g.

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20220322

• Make sure is POWERCOMPLETELY OFF at the fuse box

• Have your fixture installed by a qualified licensed electrician

• Prepare everything in a clear area

• Wear gloves at all time during this installation

• Read instructions carefully before you start assembly

• Keep this installation sheet for future reference

Technical Support: 1-855-855-8926

Please Note:

• This Kuzco LED fixture comes with pre-wired LED module(s)

• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary

contact with the module could cause permanent damage

• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application

• 120V input

Produktspecifikationer