Liftmaster 50-CP4 Bruksanvisning
Sidor 2 Engelska Inte kategoriserad
Läs bruksanvisningen för Liftmaster 50-CP4 gratis online eller ladda ner PDF:en. Bruksanvisningen har visats 31 gånger. Fråga om modellen? Ställ en fråga
INSTALLATION INSTRUCTIONS FOR
CP-4 AUTOMATIC GATE OPENER*
1. SERIAL NUMBER
There is a barcode serial number on the boom
of “puck” and on the product box. When calling
to talk about your product, please have this
number handy.
PRODUCT
CODE
YEAR
MADE
SERIAL
NUMBER
2. TRENCH PIPE & CABLE
NOTE:
Warranty
void if
cable not
run in
conduit
3. CONDUIT & SLIP JOINT
Aer pulling cable through plasc conduit,
insert conduit inside slip joint on “puck.”
DO NOT GLUE (to un-install later, if needed).
NOTE: IN MOST CASES DO NOT
ADJUST SENSITIVITY OR REMOVE LID.
5. TEST SENSITIVITY
4. CONNECT TO GATE
RED
BLACK
POWER +
WHITE COMMON
YELLOWEXIT N.C.
BLUEEXIT N.O.
POWER ─
DUAL EXIT TERMINALSINGLE EXIT TERMINAL
REDPOWER +
BLACK
WHITE
BLUE FREE EXIT
or OPEN
TERMINAL
GND or COM
CP-4 works with all gate operatorspowered or ―
solar, single or dual free exit terminals.
VOLTAGE CURRENT
8-24 VAC
8-30 VDC
Standby: 30-70 µA
Alarm: 40-60 mA
SENSITIVITY ADJUSTMENT
HIGH (Default)
Detects vehicle going
5 MPH 12-14’ away
1 & 2 in OFF position
MEDIUM
Detects vehicle going
5 MPH 6-8’ away
1 ON & 2 OFF position
LOW
Detects vehicle going
5 MPH 2-3’ away
1 & 2 in ON position
1 2
ON
1 2
ON
1 2
ON
6. BURY CONDUIT & “PUCK”
Test unit with gate by swinging steel over
puck (or driving vehicle by). If it opens the gate
correctly, nish installaon by burying conduit
and puck 3-5" below surface.
80' - 100'
12' Note: Dip switch
color may vary
• Trench 1/2" PVC pipe
to placement of CP-4
• Smooth out enre
length of cable before
pulling thru PVC pipe
• Gently pull cable thru
PVC pipe (may need
wire lubricant)
*Patent Pending
Produktspecifikationer
| Varumärke: | Liftmaster |
| Kategori: | Inte kategoriserad |
| Modell: | 50-CP4 |
Behöver du hjälp?
Om du behöver hjälp med Liftmaster 50-CP4 ställ en fråga nedan och andra användare kommer att svara dig