Liftmaster CPS-OPEN4 Bruksanvisning

Liftmaster Inte kategoriserad CPS-OPEN4

Läs gratis den bruksanvisning för Liftmaster CPS-OPEN4 (8 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 10.5 recensioner. Har du en fråga om Liftmaster CPS-OPEN4 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/8

LIFTMASTER® PROTECTOR SYSTEM

MODEL CPS-OPEN4

APPLICATION

LiftMaster® Protector System model CPS-OPEN4 is a monitored entrapment protection device for use with sectional and rolling doors. This device is

compatible with LiftMaster Heavy, Standard, and Medium Duty Logic (post 2010), FDC, FCL, FDOA, FDOB, and Egress Commercial Door operators. This

device may be installed in areas exposed to rain or moisture. These images in this document are for reference only and your product may look different.

SPECIFICATIONS

Power Consumption: Max. 50mA

Supply Voltage: 6 to 40 Vdc

Operating Temperature: -13°F to 165°F (-25°C to 73°C)

NEMA4 rating

CARTON INVENTORY

Photoelectric sensors (transmitter and receiver), mounting brackets (2), hardware, and instructions

LIFTMASTER® PROTECTOR SYSTEM

IMPORTANT INFORMATION ABOUT THE PHOTOELECTRIC SENSOR

Be sure power to the operator is disconnected.

When properly connected and aligned, the photoelectric sensor will detect an obstruction in the path of its beam. If an obstruction breaks the beam while

the door is closing, the operator will stop and typically reverse to the full open position.

The transmitter must be installed so that it faces the receiver across the entrapment zone, no more than 6" (15 cm) above the ﬂ oor for a door. Minimum

installation width of 3 feet (.91 m) and maximum width of 45 feet (13.7 m).

The brackets must be securely fastened to a solid surface such as the wall framing. If installing in masonry construction, add a piece of wood at each

location to avoid drilling extra holes in masonry if repositioning is necessary.

The invisible light beam path must be unobstructed. No part of the door (or door tracks, springs, hinges, rollers or other hardware) may interrupt the

beam while the door is closing.

ENTRAPMENT ZONES