Liftmaster LA400UL Bruksanvisning


Läs gratis den bruksanvisning för Liftmaster LA400UL (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 24 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 12.5 recensioner. Har du en fråga om Liftmaster LA400UL eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
Doc 6001309 (01-20289) Page 1 of 2 Rev A
Use the following procedure to remove and replace a LiftMaster Swing Gate Operator cover:
WARNING
Failure to follow the instructions in Step 1 may cause injury due to unexpected gate movement.
Always wait one minute after power-off to service the gate.
1. Turn off power to the gate operator at the circuit breaker and wait for one minute. The gate
will move after one minute if system has the Power Fail Option.
2. When you are certain that the gate will not move due to Power Fail Option operation:
A) Disconnect the Drag Link from the gate Anchor.
B) Loosen the locking nut and mounting bolt, then remove the Swing Arm Cap Assembly and
Drag Link Assembly from the drive shaft. Set this assembly aside.
3. Remove the four cover mounting bolts and remove the gate operator cover.
4. If new cover has optional door: Remove the two top mounting screws from the control box clear
plastic cover. NOTE: These screws must be removed or the control box clear plastic cover cannot
be removed through the gate operator cover door.
5. Install the new gate operator cover and secure with mounting hardware.
6. Reinstall the Drag Link, Swing Arm and Swing Arm Cap Assemblies.
7. Turn on power to the gate operator at the circuit breaker.
Swing Gate Cover Removal and Installation.
SWING GATE OPERATOR COVER
REMOVAL AND INSTALLATION
(WITH OR WITHOUT DOOR)


Produktspecifikationer

Varumärke: Liftmaster
Kategori: Inte kategoriserad
Modell: LA400UL

Behöver du hjälp?

Om du behöver hjälp med Liftmaster LA400UL ställ en fråga nedan och andra användare kommer att svara dig