Liftmaster LA412UL Bruksanvisning


Läs gratis den bruksanvisning för Liftmaster LA412UL (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 5.5 recensioner. Har du en fråga om Liftmaster LA412UL eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
Doc 6001309 (01-20289) Page 1 of 2 Rev A
Use t
he following procedure to remove and replace a LiftMaster Swing Gate Operator cover:
WARNING
Failure to follow the instructions in Step 1 may cause injury due to unexpected gate movement.
Always wait one minute after power-off to service the gate.
1. Turn off power to the gate operator at the circuit breaker and wait for one minute. The gate
will move after one minute if system has the Power Fail Option.
2. W
hen you are certain that the gate will not move due to Power Fail Option operation:
A) Disconnect the Drag Link from the gate Anchor.
B) Loosen the locking nut and mounting bolt, then remove the Swing Arm Cap Assembly
and
Dr
ag Link Assembly from the drive shaft. Set this assembly aside.
3. Rem
ove the four cover mounting bolts and remove the gate operator cover.
4.
If new cover has optional door: Remove the two top mounting screws from the control box clear
plastic cover. NOTE: These screws must be removed or the control box clear plastic cover cannot
be removed through the gate operator cover door.
5. I
nstall the new gate operator cover and secure with mounting hardware.
6. Reinst
all the Drag Link, Swing Arm and Swing Arm Cap Assemblies.
7. T
urn on power to the gate operator at the circuit breaker.
S
wing Gate Cover Removal and Installation.
SWING GATE OPERATOR COVER
REMOVAL AND INSTALLATION
(WITH OR WITHOUT DOOR)


Produktspecifikationer

Varumärke: Liftmaster
Kategori: Inte kategoriserad
Modell: LA412UL

Behöver du hjälp?

Om du behöver hjälp med Liftmaster LA412UL ställ en fråga nedan och andra användare kommer att svara dig