Louis Tellier 208030 Bruksanvisning


Läs gratis den bruksanvisning för Louis Tellier 208030 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 3.8 stjärnor baserat på 7.5 recensioner. Har du en fråga om Louis Tellier 208030 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
208030 en ma 2012.07
*208.030 TRITURATOR - MANUAL
MOULIN N°5
INSTRUCTIONS
ASSEMBLY
1. Set the hopper on the brim of a pan: the support bears
two side hooks provided for this purpose.
2. Place the sieve with the 3 slots facing the 3 studs,
than rotate it slightly, without blocking it.
3. The shaft-handle and cross-piece assembly are then
centred on the sieve spindle and blocked as the right
place with the two holding springs placed on each side
of the hopper.
The two clips of the cross-piece are used to hold the two
springs.
The triturator is ready for use.
DISMANTLING
1. Press on the two holding springs, in order to have the clips
of the cross-piece drop down by themselves. Pull out the
shaft by rotating it clockwise, so as to keep clear of the
stopping blade.
2. Seize the sieve in both hands, by the outer side, and
unfasten with a dead blow anti-clockwise.
NOTE
When the machine is new, the inside of the sieve is rough,
in order to make the L.T. TRITURATOR effective.
On the. contrary, when the inside of the sieve is becoming
smooth, it must be replaced.
M5002
X5002
shaft, handle and cross-piece assembly
M5001
X5001
hopper with holding springs
M5004
X5004
hopper support
M5010-15-20-30-40
X5010-15-20-30-40
sieve
M5003
X5003
holding spring
full-sized sieve perforations
1 mm 1,5 mm 2 mm 3 mm 4 mm


Produktspecifikationer

Varumärke: Louis Tellier
Kategori: Inte kategoriserad
Modell: 208030

Behöver du hjälp?

Om du behöver hjälp med Louis Tellier 208030 ställ en fråga nedan och andra användare kommer att svara dig