Metra TE-FTGC Bruksanvisning

Metra Dashcam TE-FTGC

Läs gratis den bruksanvisning för Metra TE-FTGC (2 sidor) i kategorin Dashcam. Guiden har ansetts hjälpsam av 26 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 13.5 recensioner. Har du en fråga om Metra TE-FTGC eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
REV. 05/21/2018
TE-FTGC/TE-FCTGC (CMOS)
FORD F150 (2004-2014)
Note: Excludes 2004 Heritage model
Replacement Tailgate Handle
with Camera
Removal and Installation
Instructions
Tools Needed: T30 torx bit, ratchet, 10mm socket.
NOTE: Some trucks will have 6 or 8 torx screws on bed liner
cover (if equipped).
1. Start by lowering the tailgate and remove
the (6 or 8) T30 torx screws from the bed
liner. (Fig. A)
NOTE: if your truck doesn’t have a liner
please advance to the next step.
2. Remove the tailgate liner, you will see (2)
torx screws on the tailgate access panel.
These must be removed to gain access to the
tailgate handle. (Fig. B)
3. After the removal of the (2) T30 torx screws,
remove the tailgate access panel and place
aside. (Fig. C)
4. Now that you have access to the handle, you
will see (2) 10mm nuts securing the handle
in place. Remove these nuts. (Fig. D)
5. Gently remove handle by lifting the handle
from the outside and slowly working it out.
6. Now that the handle is out of the tailgate,
you will have to swap the locking mechanism
out of the old handle to the new one. (Fig. E)
Fig. A
Fig. B
Fig. C
Fig. E
Fig. D


Produktspecifikationer

Varumärke: Metra
Kategori: Dashcam
Modell: TE-FTGC

Behöver du hjälp?

Om du behöver hjälp med Metra TE-FTGC ställ en fråga nedan och andra användare kommer att svara dig