NAV-TV NTV-KIT987 Bruksanvisning

NAV-TV mottagare NTV-KIT987

Läs gratis den bruksanvisning för NAV-TV NTV-KIT987 (7 sidor) i kategorin mottagare. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 3 recensioner. Har du en fråga om NAV-TV NTV-KIT987 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/7
Ferrari Portono M.O.S.T. 150 to 12-channel Analog & Digital sound processor
NTV-KIT987
3950 NW 120
th
Ave, Coral Springs, FL 33065 TEL 561- -9770 FAX 561- -955 955 9760
DES
12/01/ 2020
2 | P a g e
ZEN- Compability F
Ferrari Portono
with MOST 150 ber
optic amplier
NTV-ASY319
The NAV-TV ZEN-F processor seamlessly converts Ferrari Portono factory MOST-150 audio bus to -channel 12
analog RCA and TOSLink output. Adding aermarket ampliers to the OE Ferrari system has never been so
simple. This kit integrates with the OEM M.O.S.T.® bus to retain volume control, full fade (and balance analog :
only) treble, mid-range & Bluetooth voice calls with no external speaker (true OEM integraon). , NOTE: OEM
radio systems not equipped with a ber opc amplier are not compable.
ZEN-F overview
Overview
Kit Content
Year(s)
Make
Model
2017+
Ferrari
Portofino with MOST 150 ber opc amplied audio system
ZEN Pow
NTV-H
le pdates)
CAB009
Power
connector
USB (updates)
TOSLink output
MOST 150 fiber input
--FUTURE USE--
Analog RCA outputs
WARNING: Do not connect any RCA cables to the ZEN-F interface or
addional processors prior to properly grounding aermarket amplier(s)!
DIP switches
Status LED
--FUTURE USE--
DES
12/01/ 2020
3 | P a g e
Wire Side
Keep in
factory
default
*This remote wire must be used for aermarket amplier remote for proper funconality. If installing more than
one amplier/DSP, a relay must be used for reliable turn-on (500mA max).
ZEN-F Installaon
1. If this vehicle has a factory amplier, it must be removed and the -F can be installed into its place. ZEN
If this vehicle is not amplied from factory, it is not compable with the ZEN-F .
2. Connect the following wires from the
provided power harness:
3. Before connecng power to the ZEN-F, adjust dip-switch sengs for the desired opons:
4. If using analog RCAs for signal to the amplier, connect according to the reference chart below.
WARNING: Do not connect RCA cables to this interface unl all ampliers/external processors are
properly grounded. Failure to do this may cause damage to the interface and VOID the warranty!
1
2
3
4
5
6
7
8
9
10
11
12
Le
Front
Right
Front
Le
Front
Right
Front
Le
Front
Right
Front
Le Rear
Door
Right Rear
Door
Le Rear
Center
Right Rear
Center
Center
Sub
5. If using TOSLink for signal to the amplier, connect the cable to the TOSLink port shown on page 2.
NOTE: both Analog and Digital output sound simultaneously, regardless of which type is used.
6. Connect the provided MOST Fiber Cable from the (previously removed) amplier, or from the radio’s
ber port to the MOST port on the ZEN-F .
ZEN-F General Installaon Notes
This interface can only be installed in vehicles with a factory MOST ber opc amplier .
1. The factory amplier must be removed. Connect the OEM ber previously connected to the amp,
directly into the -F ZEN .
ZEN-F pin
Color
To vehicle:
1
Yellow
12v (+) Constant
3
Violet
--Reserved, NOT USED --
4
Black
Ground (-)
6
Blue
12v (+) remote output*
Time Alignment
Aenuaon
TOSLink DownM ix
Loudness
Vehicle Sengs
Posion
DIP 1
DIP 2
DIP 3
DIP 4*
DIP 5
DIP 6
UP
(o)
Front Row
Full Scale
output (0 dB)
Not used
Loudness OFF
DOWN
(on)
Driver Focused
-12 dB output
Not used
Loudness ON

Produktspecifikationer

Varumärke: NAV-TV
Kategori: mottagare
Modell: NTV-KIT987

Behöver du hjälp?

Om du behöver hjälp med NAV-TV NTV-KIT987 ställ en fråga nedan och andra användare kommer att svara dig