Ozito PXGAR-500 Bruksanvisning

Läs gratis den bruksanvisning för Ozito PXGAR-500 (4 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 4 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 2.5 recensioner. Har du en fråga om Ozito PXGAR-500 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/4
1
ASSEMBLY INSTRUCTIONS
1223
PXGAR-500
ROBOT LAWN
MOWER GARAGE
ozito.com.au
CONTENTS
8 x Ground Anchor Screws
Hex Key & Fasteners
2
KNOW YOUR PRODUCT
1. Garage Hood
2. 2 x Lock
3. 2 x Foot
4. 2 x Threaded Pin
5. 2 x Nut
6. 4 x Cross-Head Screw
7. Hex Key
8. Strut - Short
9. 8 x Ground Anchor Screws
10. Strut - Long
11. Hex Key Storage
ROBOT LAWN MOWER GARAGE
1 2 3
4 5 6 7 9 10 38
112
SETUP & PREPARATION
STRUT - Short
STRUT - Long
3
Assembly
1. Align the pre-drilled hole in the end of each Strut with the corresponding hole in each of the
Feet. With the holes aligned fasten together using the four Cross-Head screws.
WARNING! NEVER STAND OR SIT ON THE ROBOT LAWN MOWER GARAGE.
THE GARAGE IS TO BE USED ONLY FOR ITS PRESCRIBED PURPOSE.
Proper Use
The robot lawn mower garage is designed to protect your robot lawn mower and its charging
station from weather conditions such as rain and sun. The garage does not protect your robot
lawn mower from lightning.
2. Place the Garage Hood on
the Feet and t the two Nuts
on the outside in the recess.
Push the Threaded Pins
from the inside through the
Garage Hood, then through
the Feet and into the two
Nuts. Fully tighten the
Threaded Pins with the Hex
Key.

Produktspecifikationer

Varumärke: Ozito
Kategori: ej kategoriserat
Modell: PXGAR-500

Behöver du hjälp?

Om du behöver hjälp med Ozito PXGAR-500 ställ en fråga nedan och andra användare kommer att svara dig