Philips HTL2060 Bruksanvisning

Läs gratis den bruksanvisning för Philips HTL2060 (1 sidor) i kategorin Soundbar. Guiden har ansetts hjälpsam av 49 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 6 recensioner. Har du en fråga om Philips HTL2060 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

RESET

MUTE

EQ

VOL+

VOL-

AUD

USB

BT

ARC

OPT

1098711

总尺寸：660x173mm

工艺：风琴折铜版纸双面印刷 105G

成品尺寸：110x86.5mm

料号：30709L003102-003

成品正面：成品背面：

SOUNDBAR

HTL2060

User maalnu

SOUNDBAR

HTL2060

User manual

System potiosining :

The subwoofer is recommended to be put

Helpful Hint:

- To avoid magnetic interference, do not position

the speakers, too close to your TV.

Playing the speakers and subwoofer

Audio source / player

SOUNDBAR

The soundbar is recommended to be put on

the at desktop to get a better acoustic eect.

Warranty

1. Proof of purchasesotompied with this warranty rd. i n accanca

2. The warranty card is not completed immediately after purchase.

3. The apparatus is not used according to this user manual.

4. Defectsreused due toproper or reckless use. a ca im

5. Any repairs are done by persons other than Philips authorized service centre.

6. The serial number is tampered with.

7. Defects due touses beyond ca control like lightg,bnormaloltage or while trsit to the nin a v inan

purchaser’s residence.

Product Sl. No.

Model No.

Invoice Number

Date of Purchase: / /

Customer’s Name and address:

PIN:

Always there to help you!

Visit us at www.support.philips.com

Helpline: 1800 425 6396

Email: india.callcentr[email protected]

(10 a.m. to 9 p.m. Mondays to Saturdays & 10

a.m. to 6 p.m. on Sundays)

Dealr eName& Stamp:

This Philips soundbar is warranted against any defect due to defective materials or workmanship for 12 months

from the date of purchase, should a defect develop during the warranty, TPV Technology India Pvt. Ltd.,

its authorized service center in India.

FREE OF CHARGE at any of

General information

Safety instructions

Plea r carefully t safety mark on back sideseeadhethe

This mark is intended to alert the user from

the non isolated dangerous voltage within the

constitute a risk of electric shock to persons.

This mark is intented to alert the user for

important operating and servicing instruction.

Warnings

•

Avoid sustained periods on high-volume use, and

do not turn the volume to maximum level while using

high output signal, such as Mobile Phone or DVD,

etc., as this will cause distortion and may damage the

loudspeaker cones.

•

when not in use.

• Do not open the cover or back panel to avoid

electrical shock or any other accidents. No user-

serviceable parts are inside.

• Only for indoor use.

• Plug the system to the AC outlet with the right voltage

marked on the back panel of the Subwoofer and soundbar.

•The MAINS plug is used as the disconnect device, the

disconnect device shall remain readily operable.

Accessories

The product shall not be exposed to dripping or splashing

be placed on the product.

•

Connections

Soundbar back panel

Top panel operation

Remote controls

* AVAILABLE IF CONNECTED* AVAILABLE IF CONNECTED

Bluetooth Operating Instruction

1. Rm Press SOUCE key fro soundbar orreote mc ontrol toBluetoothmode ;

2. Bluetooth When selecting m anode, BT light will start blinking and youwill hear audBluetooth ino toe which

pairing mode.

3.obile mFor pairing with phone or other Bluetoothdevrchiaces, se the devmed “Phice nailips ” HTL2060and

choose to pair. Once paired, the BT light will slowly ash and come up with another audio tone. BT light will

stop ash when playing music.

4. n Press ad hold“ conn ” for 3 seds from remote control i order to force disnect thecon

. Bluetooth connection

Note:While using Bluetooth,if externalcall comes, then speaker s ystem goes in m utemodein

order cy m ato protect privaof obilephone user. Opertionce resumes onthealldis c is conected.n

Troubleshooting

ProblemSolution

1. No power.

2. No sound or distorted sound.

3. The remote control does not

function properly.

4. Low hum or buzz sound.

drive cannot be read.

6. Slow operation of the USB

Check if the AC power cord is properly inserted into the AC mains socket.

Adjust the volume / select the correct source to choose the equipment

that you want to hear through the system.

Reduce the distance between the remote control and the system. Replace

the batteries with new ones / Point the remote control directly towards the

IR sensor (located on front panel of the subwoofer) / Check that the batteries

Place the product as far away as possible from electrical devices that may be

causing interference / Check power supply voltage and consult electrician.

Drive is

7. BT not working.Reduce the distance or device is not paired.

Warning -

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.

below before taking the system for repair. If you are unable to remedy the problem by following hints

mentioned in below table.

and play. / Take out USB drive and insert it again properly.

1. 2. RESET 3. MUTE 4. VOL+ 5. 6. 7.

8. VOL- 9. BT 10. ARC 11. OPT 12. AUD 13. USB 14. EQ

1. : Power ON or Standby mode.

2.RESET: To set the EQ and volume to default level.

3. MUTE: Turn volume o, short press again to activate the sound.

4. VOL+: To increase the Volume by short or long press VOL+.

5. : Play the previous song by pressing “ ” but not in audio mode.

6. : Play/ pause in USB*/BT mode and MUTE in audio mode.

7. : Play next song by pressing “ ”, but not in audio mode.

8. VOL-: To decrease the Volume by short or long press VOL-.

9. BT: Bluetooth mode.

10. ARC: HDMI ARC mode.

11. OPT: Optical mode.

12. AUD: Audio input mode.

13. USB: USB* mode.

14. EQ: POP, ROCK, JAZZ, CLASSIC, COUNTRY, NORMAL.

(1)

(2)

(8)

(4)

(5)

(9)

(14)

(12)

(3)

(7)

(10)

(11)

(13)

(6)

1. Bass connection.

2. Input Connect to sound sources such as computer, CD player, MP3, etc.

3. Headphone output.

4. Optical Input.

5. HDMI ARC Input.

(1)

(2)

(3)

(4)

(5)

1. /SOURCE

2.

3. /VOL-

4. /VOL+

5.

1. /SOURCE: The Speaker system is in stand by mode when power on,

with LED lights on. Please press the “ /SOURCE” to select

appropriate source. Keeping the “ /SOURCE” key pressed for long

will put it back in stand by mode.

You can toggle through the input modes by pressing the “ /SOURCE”

key. “BT” denotes Bluetooth Mode, “ARC” denotes HDMI ARC Mode,

“OPT” denotes Optical Mode, “ AUDIO IN ” denotes Audio Mode,

“ ” denotes USB* mode.

2. : Play/Pause the songs.

3. /VOL-: Long press for volume decrease/ short press for prev track.

4. /VOL+: Long press for volume increase/ short press for next track.

5. : USB* Slot.

ItemRemote controlUser manual

Quantity1

Audio-2RCA cable

111

Optical cable

1

Connection cable

Total system power60W RMS

Soundbar power 15 x2W RMS

Subwoofer power 30W RMS

Separation

SNR

Audio input socketAudio-2RCA cable

Power consumption

12.7 W

Subwoofer1 Way

Speaker size5.25 inches

Impedance4 Ohm

Frequency range60Hz - 150Hz

Dimension (mm) W x H x D

120 x 380 x 260

Weightkg2.88

Soundbar

Speaker size

Impedance

Frequency range

Product DensiomW Dimn (m) xH x

Net Weight

BTversioV5. n0

437x 88 x 62

2 Way

2.25 inches * 2

8 Ohm

140Hz - 20KHz

1.20 kg

BT range

USB max capacity

playability

Up to 32GB

Up to 10 meters

MP3 track

>55db

>40db

*** Do NOT use USB for charging devices which can cause damage to

youexternal devicer s.thank you.

USB

(4)

(3)

(1)

(2)

(5)

/SOURCE

/VOL+

/VOL-

Care and safety information

Avogh teratur, moture, water and id hiempesisdust

•

Apparatus should not be exposed to dripping or

splashing of liquid.

• Do not place any source of danger on the Subwoofer,

• Do not install near heat sources.

Do not block any ventilation opening

•

Place the apparatus in a location with adequate

ventilation to prevent internal heat build up. Allow at

least 10cm (4 inches) of free space all around the

apparatus for adequate ventilation.

• At high volume the back cover of Subwoofer becomes

hot. Do not touch it.

Care of the cabinet

•

Use a soft cloth slightly moistened to clean the cabinet.

Do not use a solution containing alcohol, spirits,

ammonia or abrasives.

•

Attentioshould be drawto the environmental n n

aspects of batterdisposal.y

• Batteries shall not be exposed to eessive heat suchs xc a

Remark:

In order not to disturb in the dark, the LED display of soundbar is set to be o,

if there is no operation after 90 seconds of stand by mode.

Remark:

In order not to disturb in the dark, the LED display of soundbar is set to be o,

if there is no operation after 90 seconds of stand by mode.

AUDIO IN

BASS

OPT

ARC

Produktspecifikationer