Pyle PLR2DN Bruksanvisning
Pyle
Inte kategoriserad
PLR2DN
Läs gratis den bruksanvisning för Pyle PLR2DN (16 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 7 personer och har ett genomsnittsbetyg på 3.5 stjärnor baserat på 4 recensioner. Har du en fråga om Pyle PLR2DN eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/16
www.PyleUSA.com
2
To ensure correct operation and avoid damage,
please read this user manual carefully before using this product.
INSTALLATION
Installation Procedures
First complete the electrical connections and then check for correctness.
Installation Opening
This unit can be installed in any dashboard having an opening as shown below.
To Install the Car Radio
Be sure you test all connections rst, and then follow these steps to install this unit.
1. Make sure the ignition is turned o, and then disconnect the cable from the
vehicle battery’s negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. ” brackets (2pcs) on the both sides of the car receiver with screws Attach the “L
(M5.5 x 7) as shown as the below gure. The others xing screws that x the
other terminal of the “ ” metal bracket, please buy from your dealer according L
to the drilling of holes size.
4. Consult with you nearest dealer if installation requires the drilling of holes or
other modications of the vehicle.
5. Install this car receiver in the dashboard.
6. Make wiring connections, as illustrated in the “Wiring Diagram.”
7. Install the plastic outer trim ring.
103 mm
182 mm
www.PyleUSA.com 3
INSTALLATION
Connect all wiring harness and slide the head unit into the mounting collar
until it clicks into place.
Wiring Connections
ANT: Radio Antenna Socket
FL: Front Left Pre-Amp RCA Output (White)
FR: Front Right Pre-Amp RCA Output (Red)
RL: Rear Left Pre-Amp RCA Output (White)
RR: Rear Right Pre-Amp RCA Output (Red)
10A: 10A Fuse
ACC/ignition (Red)
GND/ground (Black)
ANT/aerial (BLUE)
Power/battery (Yellow)
- +12V DC Negative Ground.
- Only use speakers with 4 ohms impedance.
- The maximum current of the Amp remote trigger is 200mA.
Produktspecifikationer
| Varumärke: | Pyle |
| Kategori: | Inte kategoriserad |
| Modell: | PLR2DN |
Behöver du hjälp?
Om du behöver hjälp med Pyle PLR2DN ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Pyle Manualer
11 Mars 2025
8 Januari 2025
2 Januari 2025
6 December 2024
6 December 2024
21 Oktober 2024
21 Oktober 2024
27 September 2024
26 September 2024
26 September 2024
Inte kategoriserad Manualer
- Nanuk
- Canopia
- Altrad
- Ferm
- Alga
- VS Sassoon
- Nemef
- Markbass
- Kanto
- Testo
- Juwel
- Yukon
- Fosi Audio
- A3
- Robus
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025