Reloop RMX INNOFADER Bruksanvisning

Reloop DJ-utrustning RMX INNOFADER

Läs gratis den bruksanvisning för Reloop RMX INNOFADER (2 sidor) i kategorin DJ-utrustning. Guiden har ansetts hjälpsam av 4 personer och har ett genomsnittsbetyg på 3.7 stjärnor baserat på 2.5 recensioner. Har du en fråga om Reloop RMX INNOFADER eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/2

INSTALL INSTRUCTIONS

Reloop Distribution

Global Distribution GmbH

Schuckertstr. 28

48153 Münster / Germany

Fax ++49/251/6099368

Subject to alterations.

Illustrations similar to original product.

Misprints excepted.

V1.5

Warning! Dismantling your mixer could invalidate the warranty. If you are

unsure of your ability to safely carry out this work then it is advised that

you leave it to a qualified service technician

Check compatible mixers on www.reloop.com/reloop-rmx-innofader

Safety instructions: Please always make sure the mixer is powered off

and the power plug is unplugged.

CAUTION!

For your own safety, please read this operation manual carefully before

initial operation! All persons involved in the installation, setting-up,

operation, maintenance and service of this device must be appropriately

qualified and observe this operation manual in detail. This product

complies with the requirements of the applicable European and national

regulations. Conformity has been proven. The respective statements

and documents are deposited at the manufacturer.

HOW TO REPLACE THE CROSSFADER:

Remove the fader cap and the two screws shown in the red

circle. Take off the crossfader plate carefully.

Remove the two screws shown in the red circle.

Unplug the crossfader connection cable by slightly pulling

it out of the socket connector, while holding one thumb on

the connection shaft. Please do this very carefully.

Remove the two screws shown in the red circle. Take off

the mounting plate.

Compatible with Reloop RMX-10/22i/33i/60/80 and all

future Reloop products with INNOFADER compatible logo

grey

 Now,takethemountingplateandxitontheminiInnofader

using the two screws to fasten it. Take the included adapter

cable and insert the 4Pin connection to the mini Innofader

socket.

The mounting plate should be in the correct upside-down

position to match with your mixer.

Now, plug the other end of the adapter cable to the mixer

connection.

ATTENTION: The grey adapter cable shown in the image

below must be aligned towards the grey cable from the

mixer connection. If the fader doesn‘t work at all you

probably did this wrong.

Place the mini Innofader into the unit and tighten the screws.

Please be sure the socket connector is oriented to the right

andthemountingplatesitsushandmatchesthemounting

groove.

Put the crossfader plate on the unit and place the two

screwsshownintheredcircletoxit.Putthefadercapon

the shaft.

Reconnect power cable to the mixer and power on. The

mini Innofader should now operate correctly. The Reloop

mini Innfofader is already calibrated for perfect sharpness.

If you wish to adjust the CUT IN manually please refer to

further manuals here:

www.reloop.com/reloop-rmx-innofader

Produktspecifikationer

Varumärke:	Reloop
Kategori:	DJ-utrustning
Modell:	RMX INNOFADER
Bredd:	72 mm
Djup:	14.5 mm
Höjd:	17 mm
Modell:	Fjärrkontrollenhet för mixer
Produktens färg:	Svart
Antal:	1