RetroSound WPA1 Bruksanvisning


Läs gratis den bruksanvisning för RetroSound WPA1 (2 sidor) i kategorin TV-antenn. Guiden har ansetts hjälpsam av 27 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 14 recensioner. Har du en fråga om RetroSound WPA1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
WPA1 Antenna
Installation
The WPA1 antenna is designed to mount inside your vehicle when you are not using
a traditional fender mount antenna.
1. Place the main body of the WPA1 as high in the dash as possible or using the
adhesive backing secure to the upper windshield or rear glass. Avoid placing it
near any high-current wiring.
Glass installation: Clean the mounting area with an alcohol wipe. Using a lint-free rag,
clean any residue off the window. Peel backing off the adhesive strip and press firmly to
the glass surface. Be careful not to press too hard on windshield applications.
2. Ground the WPA1 to a clean metal point close to its body with the small braided
cable and eyelet.
3. Route the antenna cable with the thin black power wire to your radio location.
Connect the thin black wire to a 12-volt ignition source or the blue power antenna
output wire of your RetroSound® radio.
4. Connect the male antenna plug into the female antenna receptacle of your radio.
www .com.retromanufacturing
Installation Guide
WPA1
Enhanced Amplied
Hide-away Antenna


Produktspecifikationer

Varumärke: RetroSound
Kategori: TV-antenn
Modell: WPA1

Behöver du hjälp?

Om du behöver hjälp med RetroSound WPA1 ställ en fråga nedan och andra användare kommer att svara dig