Shadow SH951 Bruksanvisning

Shadow Inte kategoriserad SH951

Läs gratis den bruksanvisning för Shadow SH951 (1 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 3 recensioner. Har du en fråga om Shadow SH951 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/1

Kupferfolie

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail: info@shadow-electronics.com

Installation Instruction for Shadow SH 951

Single Side Upright Bass Pickup

Sensor

Fig. 1Fig. 1

Fig. 2Fig. 2

Content:Content:

Upright Bass Transducer with 1/4” socket,

Mounting adhesive,

Copper Foil Tape

Upright Bass Transducer with 1/4” socket,

Mounting adhesive,

Copper Foil Tape

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplier with low impedance input.

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplier with low impedance input.

3. Install the sensors into the bridge slots.

4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5. Connect to appropriate amplier with instrument cable.

3. Install the sensors into the bridge slots.

4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5. Connect to appropriate amplier with instrument cable.

1. Test t sensors into the slot between the wing and foot.

Pickup should t tightly for best output (see g 1).

1. Test t sensors into the slot between the wing and foot.

Pickup should t tightly for best output (see g 1).

2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.