Shure WA333 Bruksanvisning

Shure ej kategoriserat WA333

Läs gratis den bruksanvisning för Shure WA333 (1 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 9 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 5 recensioner. Har du en fråga om Shure WA333 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/1

WA333 TA4F Adapter Instruction Sheet

27A11874 (Rev. 1) Printed in U.S.A.

Step 5

Shortening the Cable: With all new MX models being connected to the in-line preamp with a TA4F connector, it is now more difcult for an installer

to shorten the cable length. In order to change the cable length, the existing TA4F adapter must be removed, cable must be shortened, and a new

TA4F adapter must be reattached. Most TA4F parts can be reused. Installer will need to purchase a new ferrule (P/N 31A2135) in order to sucessfully

reattach adpater with ensured immunity.

Step 1: Loosen the hex set screw using a .038 hex wrench and remove the existing TA4F connector housing.

Step 2: Shorten cable to desired length. Carefully strip cable, removing the sheath.

Step 3: Loosen the copper shield/GND. Using a pointed tip, carefully unbraid strands and comb copper so it is straight.

Step 4: Comb the unbraided copper strands back against the cable and make sure copper is evenly distributed around the

cable. Strip and tin the +/- connections.

Step 5: Insert the ferrule over the copper cable, small side down. Slide the ferrule over the cable up to the bottom edge of the cup.

Step 6: Using a hexagonal .128 crimping tool, crimp the ferrule onto the cable. Make sure not to over crimp.

Step 7: Trim excess copper.

Step 8: Insert TA4F spacer and solder audio wires to TA4F.

Step 9: Twist TA4F receptacle to tighten slack.

Step 10: Reattach TA4F connector housing and tighten the hex set screw.

Diagram for Step 8

Step 6

IMPORTANT: Make sure copper does not come into the cup. Do not twist the ferrule.

Step 2

Step 8

TA4F Spacer

TA4F Receptacle

Step 7

Step 1

connector housing

Step 4

Step 3

Shield Note 2

0.725 ± 0.031

[18.42 ± 0.79]

0.575 ± 0.031

[14.60 ± 0.79]

ferrule

.038 hex wrench

0.100

[2.5]

0.150

[3.8]

Produktspecifikationer

Varumärke:	Shure
Kategori:	ej kategoriserat
Modell:	WA333
Produktens färg:	Svart
Antal per förpackning:	1 styck
Anslutning:	4-Pin (TA4F)
Kontakttyp:	Honkoppling
Kontaktens formfaktor:	Rak