Sonance R1 Bruksanvisning
Läs gratis den bruksanvisning för Sonance R1 (1 sidor) i kategorin högtalare. Guiden har ansetts hjälpsam av 13 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 7 recensioner. Har du en fråga om Sonance R1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/1
Before Installation
1. Determine the location for the speaker.
2. Perform an obstruction survey using a stud nder to be
certain that there are no obstructions.
3. Position the included cutout template where the speaker is
to be located and pencil an outline on the wall. The cut-out
for the R1 and R1CSUR are 7 1/2” x 20 1/2” (191mm x
521mm). The cut-out for the R2 and R2CSUR are
7 1/2” x 33 1/2” (191mm x 851mm).
4. Cut the mounting hole using a keyhole or drywall saw and
run the speaker wires from the mounting hole to the
amplier location.
NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING
SPEAKER WIRES THROUGH WALLS.
Installation
Reference Series speakers feature an integral RotoLock
®
mounting system for quick installation.
1. Strip 1/4” – 1/2” (6mm – 12mm) of insulation from each
speaker lead.
2. Twist the strands or tin the exposed wire with solder to
ensure that there are no stray strands.
NOTE: STRAY STRANDS THAT TOUCH EACH OTHER CAN CAUSE
A SHORT-CIRCUIT THAT CAN DAMAGE THE AMPLIFIER/RECEIVER.
4. The speaker’s positive spring terminal is labeled with a red
dot; the negative spring terminal is labeled with a black dot.
5. Make sure all the RotoLock
®
toggle feet are retracted so
that they are tucked within the speaker frame. Insert the
speaker into the hole in the wall (see Figure 2).
Box Contents
(1) Quickstart Guide
(1) Reference in-wall speaker
(R1, R1SUR, R2, R2SUR)
(1) Speaker cut-out template
7. Tighten the screws on the front of the speaker bae.
The RotoLock
®
toggle feet will automatically rotate into
position and begin clamping the speaker (see Figure 4).
When you notice resistance on the screws the speaker has
been clamped successfully.
NOTE: THE ROTOLOCK
®
SYSTEM CAN ACCOMMODATE A WALL
MATERIAL THICKNESS OF 1 1/4” (32MM). WITH THE TOGGLE
FOOT CAP REMOVED, THE SYSTEM CAN ACCOMMODATE A WALL
MATERIAL THICKNESS OF 1 1/8” (48MM).
(+)( – )
Red Dot Black Dot
Figure 1: Connecting the Speaker Wire
RotoLock
®
Clamps
(retracted)
Figure 2: Inserting
the Speaker into
the Mounting Hole
RotoLock
®
Screws
RotoLock
®
Screws
RotoLock
®
Screws
R1 / R1SUR
R2 / R2SUR
Figure 4: Tightening the RotoLock
®
Screws
8. The micro-trim grille is held in place by several small,
powerful magnets on the speaker frame. Carefully place the
grille against the speaker and the magnets will hold it rmly
in place. When properly installed, the grille trim should make
contact with the wall all the way around the speaker.
IMPORTANT: ALWAYS USE LOW-TORQUE SETTINGS; NEVER OVER
TIGHTEN. NOTE: ADJUSTING THE TENSION OF THE ROTOLOCK
®
CLAMPS SO THAT THE SPEAKER FRAME IS FLAT WILL HELP
ENSURE THAT THE GRILLE CONTACTS THE WALL ALL THE WAY
AROUND THE SPEAKER FOR A PROPER FIT.
6. When installing into double drywall or other thicker wall
materials, you may need to remove part of the two-piece
toggle feet. Use a small screwdriver to gently release the
two locking levers (Figure 3).
Remove
Cap
Locking Levers
Figure 3: Releasing the Two Locking Levers
3. The speaker’s terminals are spring-loaded. Push the top of
each terminal down to open the connector and insert the
exposed wires (see Figure 1).
R1 | R1SUR | R2 | R2SUR QUICKSTART GUIDE
REFERENCE IN-WALL SPEAKERS
09.20.17
©2017 Sonance. All rights reserved. Sonance is a registered trademark of Dana Innovations. Due to continuous product improvement, all features and specications are subject to change
without notice. For the latest Sonance product specication information visit our website: www.sonance.com
SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA • Phone: (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (949) 492-7777 33-7917
Produktspecifikationer
| Varumärke: | Sonance |
| Kategori: | högtalare |
| Modell: | R1 |
Behöver du hjälp?
Om du behöver hjälp med Sonance R1 ställ en fråga nedan och andra användare kommer att svara dig
högtalare Sonance Manualer
27 Februari 2025
27 Februari 2025
27 Februari 2025
27 Februari 2025
8 Januari 2025
8 Januari 2025
8 Januari 2025
8 Januari 2025
2 Januari 2025
16 Oktober 2024
högtalare Manualer
- Reloop
- Adam Hall
- Schneider
- Ices
- Raymarine
- Eos
- Audac
- Membantu
- Gira
- Ideen Welt
- Coby
- Epson
- Steelseries
- SSL
- Sonos
Nyaste högtalare Manualer
23 Oktober 2025
20 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
18 Oktober 2025