SPL MTC Mk2 Bruksanvisning
SPL
Inte kategoriserad
MTC Mk2
Läs gratis den bruksanvisning för SPL MTC Mk2 (13 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 23 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 12 recensioner. Har du en fråga om SPL MTC Mk2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/13

MTC Mk2
Monitor & Talkback Controller
Manual
Further information:
mtc-mk2.spl.audio
EN
DE

MTC Mk2
2
Getting started
Read the safety instructions starting on page11.
Make sure that the mains voltage of the MTC Mk2 mentioned in the specications
(page10) corresponds to the voltage of your region.
The power switch on the back of the MTC Mk2 must be in the o position.
(O = O / On = I).
Connect the supplied power cord to the power connector of the MTC Mk2 and to a power
outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the MTC Mk2 must be be switched o.
Connect the outputs of your analog sources to the analog inputs of the MTC Mk2. Please
use appropriate audio cables (TRS, RCA).
Audio cables not included in the scope of delivery.
Connect audio cables between the MTC Mk2 and following ampliers or active monitors
(XLR, TRS).
Audio cables not included in the scope of delivery.
Connect headphones to the headphone outputs of the MTC Mk2.
Warning: Never connect a mono jack cable to the front panel stereo jack. Make sure that the stereo jack is fully inserted,
otherwise a short circuit might damage the headphone amplier.
Power on
Turn down the volume and the headphone volume of the MTC Mk2.
Switch on the power switch on the rear panel of the MTC Mk2 (On = I).
The Power LED and all activated switches light up.
Power o
Turn down the volume and the headphone volume of the MTC Mk2.
Switch o the power switch on the rear panel of the MTC Mk2 (O = O).
The Power LED and all activated switches will no longer light up.

MTC Mk2
4
Loudspeakers
SUB OUT:
Mono summed
output with full
frequency range.
FOOTSWITCH:
Latching or
momentary foot
switch for
Talkback
CUE OUT:
When CUE MIX is activated, only the
signal from IN C/CUE MIX and the
talkback signal (Unity Gain). Phoni-
tor Matrix and monitoring modes are
deactivated.
TALK OUT:
Talkback signal
Produktspecifikationer
Varumärke: | SPL |
Kategori: | Inte kategoriserad |
Modell: | MTC Mk2 |
Behöver du hjälp?
Om du behöver hjälp med SPL MTC Mk2 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad SPL Manualer
26 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
Inte kategoriserad Manualer
- Callpod
- Wago
- Team
- Linksys
- Lantus
- Pericles
- Silvercrest
- C2G
- Flame
- Purell
- White Lightning
- Beha-Amprobe
- Suzuki
- Bavaria By Einhell
- Magmatic
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025