StarTech.com ST7300USBME Bruksanvisning

Läs gratis den bruksanvisning för StarTech.com ST7300USBME (2 sidor) i kategorin Annat datortillbehör. Guiden har ansetts hjälpsam av 31 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 2 recensioner. Har du en fråga om StarTech.com ST7300USBME eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Instruction Manual

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

Manual Revision: 01/19/2023

For the most up-to-date information, please visit: www.startech.com

Packaging Contents

• 1x 7-Port Industrial USB 3.0 Hub

• 1x USB 3.0 A - B Cable

• 1x DIN Rail Mounting Kit

• 1x Terminal Block Connector (2 Wire)

• 1x Instruction Manual

Installation

Connect the USB Ports

1. Connect up to seven USB peripherals to the USB 3.0 Hub Ports,

located on the USB Hub.

2. Use the included USB 3.0 A - B Cable, to connect a USB port,

located on the Host Computer USB 3.0 Host Portto the , located

on the USB Hub.

• The Computer will automatically detect the device and install

the required drivers for the USB Hub.

Power the Hub with an External Power Supply

The USB hub can operate with bus power alone, or with an external

7~48V DC Power Source2-WireTermal Block connected via the .

However, it is recommended that a DC Power Source be connected

to ensure sucient power is delivered to each USB 3.0 Port.

Congure the USB Hub to Accept an External Power Source

USB Bus Power must be disabled before the USB Hub can accept an

external power source. This is accomplished by adjusting a jumper,

located on one of the USB Hub’s PCBs. Follow the below steps to

disessemble the USB Hub and congure the jumper:

1. Using a Phillips-head screwdriver. Remove the four screws,

located on the top and bottom sides of the USB Hub (above each

of the mounting brackets), and the two screws located on the side

of the USB Hub (six screws in total).

2. Carefully remove the top metal panel from the USB Hub, and

remove the four screws, located on the upper PCB, using a Philips-

head screwdriver.

3. Carefully lift the upper PCB away from the bottom of the USB Hub,

reveiling the lower PCB. The pin culster is located USB BUS PWR

on the upper-right side of the lower PCB.

• Removing the upper PCB will disconnect the pins on either

side of the lower PCB that connects the two boards.

System Requirements

• Host Computer with an available USB port

• DC Power Source, 2-Wire 7~48V (Optional)

Product Overview

Front View

ST7300USBME

7-Port Industrial USB 3.0 Hub with ESD Protection

Power LED

USB 3.0 Host Port

USB 3.0 Hub Ports

2-Wire Terminal

Block-included

(7~48V DC Input)

Produktspecifikationer