Supermicro SuperServer 5018A-MLHN4 Bruksanvisning

Supermicro Server SuperServer 5018A-MLHN4

Läs gratis den bruksanvisning för Supermicro SuperServer 5018A-MLHN4 (1 sidor) i kategorin Server. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 1.5 recensioner. Har du en fråga om Supermicro SuperServer 5018A-MLHN4 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/1
http://www.supermicro.com MNL-1580-QRG
Board Layout
SuperServer 5018A-MLHN4 Quick Reference Guide
Beep Codes
Rear View
MEMORY
Caution
SAFETY INFORMATION
IMPORTANT: See installation instructions and safety warning
http://www.supermicro.com/about/policies/safety_information.cfm
WARNING:
To reduce risk of electric shock/damage to equipment,
disconnect power from server by disconnecting all power
cords from electrical outlets.
If any CPU socket empty, install protective plastic CPU cap
CAUTION:
Always be sure all power supplies for this system have
the same power output. If mixed power supplies are
installed, the system will not operate.
For more information go to :
http://www.supermicro.com/support
!
!
!
Descrip iot n
No.
Slot4 PCI-E 2.0 x4
Slot6 PCI-E 2.0 x8
JTPM1 = Trusted Platform Module (TPM)/Port 80 Connector
JSD1 = SATA DOM Power Connector
JBT1 = CMOS Clear
CPU1
DIMMB1(Blue)/DIMMB2
DIMMA1(Blue)/DIMMA2
I-SATA0 ~ I-SATA5 = SATA Ports 0~5
1
2
3
4
5
6
7
8
9
BIOS Error Beep Codes
Beep Code/LED Error Message Description
1 beep Refresh Circuits have been reset.
(Ready to power up)
5 short beeps + 1 long
beep
Memory error No memory detected in the
system
8 beeps Display memory
read/write error
htiw ro gnissim retpada oediV
faulty memory
OH LED On System OH System Overheat
Power Button
Reset Button
Power LED
Device Activity LED
LAN1 LED & LAN2 LED
Information LED
Hard Drive Signal
Hard Drive Fail
Description
No.
Description
No.
9
10
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
PCI-E Expansion Slot (w/riser card)
UID
VGA Port
GbE LAN1/4 Port
GbE LAN2/3 Port
USB 0/1/2/3 Ports
COM1 Port
Dedicated LAN for IPMI
Single/Redundant Power Supply Module
SATA Drive Installation
DIMMB2
DIMMB1
(Blu Sloe t)
DI A1MM
(Blu Sloe t)
DIMMA2
3
4
5
6
7
9 12
8
The SATA drives are mounted in drive carriers
to simplify their installation and removal from the chassis.
These carriers also help promote proper airflow for the
system. For this reason, even empty carriers without
drives installed must remain in the chassis.
1. Install a new drive into the carrier with the printed
circuit baord side facing down so that the mounting
holes align with those in the carrier.
2. Secure the drive to the carrier with six screws,
as shown.
Mounting a Drive in a Drive Carrier
Installing/Removing SATA Drives
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the colored handle fully and use it to pull the unit straight out.
Unbuffered (UDIMM) DDR3 Memory
DIMM Slots per
Channel
DIMMs Populat-
ed per Channel
DIMM Type POR Speeds Memory Population
Sequence
2 1 Unbuffered
DDR3 DIMM
1600,1333 A1, B1 (2 DIMMs)
2 2 Unbuffered
DDR3 DIMM
1600,1333 A1, B1, A2, B2
(4 DIMMs)
Note: Use memory modules of the same type, speed, frequency and size.
123456
HDD 0 HDD 1 HDD 2 HDD 3
JPI2C1
JL1
JOH1
JF1
JPW1
JLAN2 JLAN1
JBT1
LED8
LED7
JPK1
SP1
JBAT1
JWD1JPB1
JI2C2
JI2C1
JPG1
JPL1
JSD1
JTPM1
JIPMB1
JVGA1
JUIDB1
COM2
JD1
I-SATA1 I-SATA0
I-SATA5
I-SATA4
1
I-SATA2
FAN3
FAN3
FAN1
CPU1 SLOT4 PCI-E 2.0 X4
USB6
LAN3/4 LED
LAN2/LAN4
DIMMB2
DIMMA2
USB0/1
BUZZER
IPMI_LAN
BATTERY
DIMMB1
CPU1 SLOT6 PCI-E 2.0 X8
LAN1/LAN3
DIMMA1
USB4/5
COM1
A1SAM/A1SRM Series
USB 2/3
FPCTRL LED3
BIO
SoC Processor
BMC
PHY
JBR1
JPUSB1
JSTBY1
PWRI2C
1
2
3
6
7
8
4 5
9
!
CAUTION:
The fans on the A1SAM-2550F are not hot-swappable.
Front View & Interface
ÌMNL-1580-QRGuÎ


Produktspecifikationer

Varumärke: Supermicro
Kategori: Server
Modell: SuperServer 5018A-MLHN4
Vikt: 3620 g
Bredd: 437 mm
Djup: 503 mm
Höjd: 43 mm
Strömförsörjning: 200 W
LED-indikatorer: Ja
Processorfamilj: Intel
Minnesspänning: 1.35, 1.5 V
Kompatibla processorer: Intel Atom®
Antal processorer som stöds: 1
Antal lagringsenheter som stöds: 4
Minnestyper som stöds: DDR3-SDRAM
BIOS-typ: AMI
ACPI-version: 5.0
Produktens färg: Svart, silver
Typ av ethernet-gränssnitt: Fast Ethernet, Gigabit Ethernet
Datahastighet för Ethernet-LAN: 10,100,1000 Mbit/s
Antal LAN (RJ-45) anslutningar: 5
Temperatur vid drift: 10 - 35 ° C
Temperaturintervall (förvaring): -40 - 70 ° C
Intervall för relativ operativ luftfuktighet: 8 - 90 %
Fuktighet (förvaring): 5 - 95 %
processorsockel: BGA 1283
Seriella portar: 2
Nätverksansluten (Ethernet): Ja
BIOS-funktioner: UEFI
På / av-knapp: Ja
Antal USB 2.0 anslutningar: 7
Icke ECC: Ja
BIOS minnesstorlek: 128 mbit
Kvalitet på VGA (D-Sub) porten: 1
Ombord grafikkort modell: Aspeed AST2400
Storlekar som stöds på lagringsenhet: 3.5 "
Koppar Ethernet-kablar teknik: 1000BASE-T, 100BASE-TX, 10BASE-T
Lagringsenhetsgränssnitt som stöds: Serial ATA II
ECC: Ja
Chassityp: Rack (1U)
Antal SATA III kontakter: 2
Antalet DIMM-platser: 4
Hårddisk hot swap: Ja
Antal SATA II kontakter: 4
PCI Express x8 kortplatser: 1
Stöd för RDIMM klockfrekvenser: 1333,1600 MHz
IPMI LAN (RJ-45)-port: Ja

Behöver du hjälp?

Om du behöver hjälp med Supermicro SuperServer 5018A-MLHN4 ställ en fråga nedan och andra användare kommer att svara dig