Velleman DVM860BL Bruksanvisning
                    Velleman
                    
                    Multimeter
                    
                    DVM860BL
                
                                
    Läs gratis den bruksanvisning för Velleman DVM860BL (54 sidor) i kategorin Multimeter. Guiden har ansetts hjälpsam av 8 personer och har ett genomsnittsbetyg på 3.8 stjärnor baserat på 4.5 recensioner. Har du en fråga om Velleman DVM860BL eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
                        Sida 1/54
                    
                    
                    
   DVM860BL    VELLEMAN - 1 -
DVM860BL – DIGITAL MULTIMETER 
1. Introduction 
At the end of its life cycle, dispose of this product in accordance with local and national disposal 
regulations. Read the manual thoroughly before bringing this device into service 
Thank you for buying the  ! Use this device to measure and test: AC & DC voltage & current (also with DVM860BL
optional clamp  ), resistance, temperature, batteries, diodes, continuity and transistors.  AC97
2. Safety 
The   is developed in accordance with IEC1010-1 concerning safety requirements for electrical measuring DVM860BL
instruments with an overvoltage category (CAT III) 600V and pollution 2. Respect these safety prescriptions: 
• Protect yourself against electroshocks. 
• Do not use this device for any other application than those described in this manual. 
• Make sure the device was not damaged in transit. 
• Make sure the insulation of the test leads is not damaged and/or the wire itself is not exposed. 
• Full compliance with safety standards can only be guaranteed if the device is used with the supplied test leads. If 
necessary, they should be replaced with identical leads or leads with identical electric ratings. All test leads should 
be in good working order. 
• Select the right input jack, function and range before use. 
• Never exceed the specified limit values for the various measurement ranges. 
• Do not touch unused terminals when the meter is connected to a circuit. 
• Place the range selector in the highest position if the value to be measured is unknown beforehand. 
• Do not measure voltages > 600V above earth ground. 
• Exercise extreme caution when working with voltages in excess of 60Vdc or 30Vrms AC. Keep your fingers behind 
the probe barriers while using the device. 
• Do not connect the leads to a voltage source while the function switch is in one of the following modes: current, 
resistance, temperature, battery, diode, transistor or continuity. 
• Disconnect all test leads from the circuit to be tested prior to selecting a different function or range. 
• Do not use the meter in dusty environments or in the presence of flammable gases and steam. 
• Have the device checked by a qualified technician in case of malfunction. 
• Never use the meter if the back panel is not in place and firmly fixed. 
• Do not use or store the device in areas exposed to direct sunlight, high temperatures or high humidity. 
3. Device Description 
 a.  Front Panel 
   1.  LCD display  :  allows readout of the measured values 
 2.  ON/OFF button :  used to activate / deactivate the device 
   3.  RANGE button  :  used to select auto or manual range 
   4.  FUNC. button  :  select AC or DC measurement, select °C or °F 
   5.  Selector  :  used to select the desired function and range 
   6.  10A jack  :  input terminal for max. 10A current 
   7.  INPUT jack  :  input terminal (exception: 10A) 
 8.  COM jack 
     9.  Backlight button ( )  :  to illuminates the LCD for a few seconds 
 10. DATA HOLD button  :  Displayed data are held 
 11. MAX HOLD button  :  Max. measured value is held 
Produktspecifikationer
| Varumärke: | Velleman | 
| Kategori: | Multimeter | 
| Modell: | DVM860BL | 
Behöver du hjälp?
Om du behöver hjälp med Velleman DVM860BL ställ en fråga nedan och andra användare kommer att svara dig
Multimeter Velleman Manualer
                        
                         9 December 2024
                        
                    
                                                            
                        
                         5 Oktober 2024
                        
                    
                                                            
                        
                         5 Oktober 2024
                        
                    
                                                            
                        
                         5 Oktober 2024
                        
                    
                                                            
                        
                         22 September 2024
                        
                    
                                                            
                        
                         16 September 2024
                        
                    
                                                            
                        
                         11 September 2024
                        
                    
                                                            
                        
                         3 September 2024
                        
                    
                                                            
                        
                         2 September 2024
                        
                    
                                                            
                        
                         28 Augusti 2024
                        
                    
                                                            Multimeter Manualer
- EMOS
- Laserliner
- Parkside
- Strex
- Rohde & Schwarz
- Keithley
- Stanley
- Greenlee
- GW Instek
- Yato
- Caltek
- Testboy
- Ferm
- Bearware
- Proline
Nyaste Multimeter Manualer
                        
                         20 Oktober 2025
                        
                    
                                                            
                        
                         13 Oktober 2025
                        
                    
                                                            
                        
                         7 Oktober 2025
                        
                    
                                                            
                        
                         7 Oktober 2025
                        
                    
                                                            
                        
                         26 September 2025
                        
                    
                                                            
                        
                         26 September 2025
                        
                    
                                                            
                        
                         26 September 2025
                        
                    
                                                            
                        
                         26 September 2025
                        
                    
                                                            
                        
                         26 September 2025
                        
                    
                                                            
                        
                         26 September 2025