Ventev TW-COLOMOUNT-2 Bruksanvisning
Ventev
Inte kategoriserad
TW-COLOMOUNT-2
Läs gratis den bruksanvisning för Ventev TW-COLOMOUNT-2 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 13 recensioner. Har du en fråga om Ventev TW-COLOMOUNT-2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
Mounting Instructions
Note: The Co-Locating Mount can be mounted on any at surface including, but not limited to, walls, ceilings, and I-beams. Mounting hardware
is not included with this product. User should identify the mounting surface and then purchase the appropriate mounting hardware.
Caution: Ensure the mounting surface will support the fully assembled unit’s weight including the mount itself, the access point, and the antenna.
Figure 2
2. Detach the circular Surface Mounting Plate from the Access Point Mounting Plate by
unscrewing the Chase Nipple nut. Set aside the Chase Nipple nut for later use. Retain the
Chase Nipple within the Surface Mounting Plate.
Figure 3
3. Set aside the combined Access Point Mounting Plate/Antenna Mounting Tray for later use.
Figure 4
4. Place the Surface Mounting Plate over the desired mounting location, with the four Surface
Mounting Stand-Os touching the mounting surface.
5. Pull the RJ-45 cable through the Chase Nipple and allow it to hang loose.
6. Insert four screws or bolts into the four Surface Mounting Holes. Tighten the screws/bolts
until the Surface Mounting Plate is secure against the mounting surface.
Figure 4
Figure 3
Surface
Mounting
Stand-os
Dry Wall Mounting:
- 4x Wall Anchors
- 4x Dry Wall Screws that t the holes shown in Figure 2.
Wood Wall Mounting:
- 4x Wood Screws that t the holes shown in Figure 2.
- 4x Locking Washers
Metal Surface Mounting
- 4x Metal Screws that t the holes shown in Figure 2.
- 4x Flat Washers
- 4x Locking Washers
Recommended Hardware:
Locking Screws
Antenna
Mounting
Tray
Cable
Management Clips
Swing Arm
Locking Tab
Thumb
Screws
TToward Antenna
Coverage Area
TToward Mounting
Surface
Access Point
Mounting Plate
Surface Mounting
Plate
4x Surface
Mounting Holes
Chase Nipple
Chase
Nipple Nut
Chase
Nipple
Threads
Surface
Mounting
Plate
Figure 1
1. Major parts of the Dual Axis Co-Locating Mount. Refer to it as required for the remaining steps.
Produktspecifikationer
| Varumärke: | Ventev |
| Kategori: | Inte kategoriserad |
| Modell: | TW-COLOMOUNT-2 |
Behöver du hjälp?
Om du behöver hjälp med Ventev TW-COLOMOUNT-2 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Ventev Manualer
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
25 September 2024
Inte kategoriserad Manualer
- Suprema
- Audient
- Xiaomi
- Weber
- Yamato
- Elgato
- SMS
- DoughXpress
- Eldom
- Anslut
- Middle Atlantic Products
- Ionmax
- Stabo
- Olympus
- STI
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025