Yakima HoldUp Bruksanvisning
Yakima
Cykelhållare
HoldUp
Läs gratis den bruksanvisning för Yakima HoldUp (21 sidor) i kategorin Cykelhållare. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 2 recensioner. Har du en fråga om Yakima HoldUp eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/21
1034426J-1/21
SAFETY CLIP (1X)
WRENCH (1X)
REAR WHEEL TRAY
ASSEMBLY (1X)
FRONT WHEEL TRAY
ASSEMBLY (1X)
HITCH BOLT (1X)
1 1/4" BASE (1X)
(1 1/4" HOLDUP ONLY)
2" BASE (1X)
(2" HOLDUP ONLY)
LOCK WASHER (1X)
KEY (2X)
HEX WRENCH (1X)
HITCHLOCK (1X)
For Your
Safety
Warranty
Registration
on-line
YAKIMA.com
Install This product on 2" OR 1¼" hitch
receivers ONLY.
Do not use with hitch-extenders or with
1 ¼” hitch adapters.
Do not install on trailers, campers, or RVs.
Do not install if spare tire causes
interference with bikes, or folded carrier.
Not for use on bikes with front fenders.
In addition, some undersized receivers may
not accept this product. If you do not know the
capabilities of your hitch receiver, consult an
automotive professional.
IMPORTANT WARNING
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR
TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS
PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU
MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION
OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT
THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER.
1034426J-2/21
INSERT BASE INTO
HITCH RECEIVER.
The holes in
the base must
align to the
holes in the
hitch receiver.
FASTEN HITCH BOLT.
Insert hitch bolt and lock washer, from RIGHT TO LEFT.
Tighten with wrench.
REMOVE FASTENERS.
The fasteners are installed in the trays
for shipping purposes. Remove them to
prepare for assembly.
SECURE HITCH
BOLT WITH
SAFETY CLIP
AND INSTALL
HITCHLOCK.
ROTATE BASE TO
UP POSITION.
Squeeze knob to release lock.
Pull spring pin to release base.
Lift frame.
Release spring pin. Pin should
snap into place and lock.
1 1/4" - 75 ft-lbs.
2" - 100 ft-lbs.
1034426J-3/21
ATTACH FIRST TRAY TO BASE.
LOWER TRAY:
IMPORTANT: Wheel strap
is to your right, and pivot
arm is to your left.
wheel strap
pivot arm
ATTACH SECOND TRAY TO BASE.
pivot arm
wheel strap
Align holes in tray to be centered in slots on base.
Insert bolt, washer, and lock-washer, in order shown.
Finger tighten all four bolts.
Tighten with supplied wrench.
Align holes in tray to be centered in slots on base.
Install bolt, lock-washer, and washer, in order shown.
Finger tighten all four bolts.
Tighten with supplied wrench.
UPPER TRAY:
IMPORTANT: Wheel
strap is to your left, and
pivot arm is to your right.
17 ft-lbs.
17 ft-lbs.
Produktspecifikationer
| Varumärke: | Yakima |
| Kategori: | Cykelhållare |
| Modell: | HoldUp |
Behöver du hjälp?
Om du behöver hjälp med Yakima HoldUp ställ en fråga nedan och andra användare kommer att svara dig
Cykelhållare Yakima Manualer
19 Oktober 2024
11 Oktober 2024
10 Oktober 2024
3 Oktober 2024
18 September 2024
29 Augusti 2024
28 Augusti 2024
21 Augusti 2024
21 Augusti 2024
19 Augusti 2024
Cykelhållare Manualer
- Menabo
- Erickson
- Saris
- Fischer
- Cruz
- Master Load
- XLC
- Peruzzo
- EQ Max
- Buzz Rack
- Thule
- Bosal
- Halfords
- Scosche
- UEBLER
Nyaste Cykelhållare Manualer
1 April 2025
3 Februari 2025
26 Januari 2025
25 Januari 2025
8 Januari 2025
2 Januari 2025
30 December 2025
30 December 2025
30 December 2025
19 Oktober 2024