Akg PZM-185 Bruksanvisning
Läs gratis den bruksanvisning för Akg PZM-185 (2 sidor) i kategorin mikrofon. Guiden har ansetts hjälpsam av 26 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 13.5 recensioner. Har du en fråga om Akg PZM-185 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
®
T
5.90"
(
15.0 CM)
PRESSURE
ZONE
MICROPHONE
®
PZM185
he PZM185 is a Pressure Zone Micro-
phone
®
for general-purpose use. Ideal for
applications such as conferences, group
discussions, interviews, broadcast, home video
production, lectures, and recordings. The mic
can be placed on a large surface such as a
table, floor, wall, or lectern.
The PZM185 is powered either by an internal
AAA 1.5V battery or 12-48 volt phantom power.
The boundary “paddle” can be detached so the
mic will fit in your pocket. Attached to the mic is
an 8-foot (2.438-m) cable leading to a tubular
power module.
The microphone’s low-profile design reduces
“mic fright” and minimizes clutter. It is nearly
invisible on camera. The PZM185 minimizes
pick up of vibration and handling noise.
Its electret condenser capsule provides a wide,
smooth frequency response from 50 Hz to
16 kHz . The mic’s hemispherical polar pattern
allows clear pickup of everyone surrounding
the microphone.
The PZM185 is protected against static and
RFI. The output is balanced, low impedance,
which allows long cable runs without hum
pickup or high-frequency loss.
Like other Pressure Zone Microphones, the
PZM185 uses a miniature mic capsule
mounted very near a sound-reflecting plate or
boundary in the Pressure Zone. In this zone,
direct sound from the sound source combines
Specifications
Element: Electret condenser.
Frequency response (typical): 50 Hz to 16 kHz
(see Fig. 1.)
Polar pattern: Hemispherical (half-omni) on a large
surface.
Impedance: 150 ohms, balanced. Recommended load
impedance 1000 ohms.
Open circuit sensitivity (1.5V battery power):
0.8mV/Pa (–62 dB re 1 volt/Pa* ).
Power sensitivity (1.5V battery power): –59.5 dBm.
EIA sensitivity –154 dBm.
Open-circuit sensitivity (phantom power):
3.2 mV/Pa* (–50 dB re 1V/Pa).
Power sensitivity (phantom power): –47.5 dBm.
EIA sensitivity –142 dBm.
Equivalent noise level (self-noise): 21 dB SPL typical,
A-weighted (0 dB = .0002 dyne/cm
2
).
S/N ratio: 73 dB at 94 dB SPL.
Maximum SPL: 120 dB SPL produces 3% distortion
Optional accessories: A K G / C r o w n PH 4B phantom
power supply (4 channels, ACpowered).
A K G / C r o w n PH 1 A phantom power supply
(1 channel, battery or AC powered).
* 1 pascal = 10 dynes/cm
2
= 10 microbars = 94 dB SPL.
Fig. 1
Frequency Response
+15
+10
+5
dB 0
–5
–10
–15
–20
–25
–30
–35
in phase at all frequencies with reflected sound
off the boundary. The benefits are many: 6 dB
more sensitivity, 6 dB less noise, a wide smooth
frequency response free of phase interference,
excellent clarity and “reach,” and consistent
pickup anywhere around the microphone.
Operating Instructions
You can power the PZM185 either by 12-48
volt phantom power or battery power. To use
phantom power, plug the mic connector into a
phantom power supply or into a mic input that
provides 12-48 volt phantom power.
To use battery power, open the cover
(see Fig. 3) and insert a AAA 1.5V battery.
Please note the correct orientation of the
battery.
If you’re using the microphone on a hard sur-
face, such as a table top, the boundary “paddle”
is not necessary. If you’re using the mic on a
carpet or other sound-absorbing surface, attach
the boundary “paddle” for best results.
with phantom power.
Polarity: Positive pressure on the diaphragm produces
positive voltage on pin 2 with respect to pin 3 of the
output connector.
Cable: 8 foot (2.438m), 2-conductor shielded, perma-
nently attached. No other cable supplied; use 2-
conductor shielded mic cable.
Output connector: 3-pin XLR-type pro audio connector.
Operating voltage: One 1.5-volt size AAA alkaline
battery (Duracell MN2400 or equivalent) or 12 to
48V phantom power (positive voltage on pins 2 and
3 with respect to pin 1).
Battery life: Approximately 45 days.
Current drain: 0.5 mA.
Materials: High-impact plastic housing and steel
power module.
Finish: Satin black.
Dimensions: See Fig. 2.
Weight: 4 ounces (115 grams).
Included accessories: 1.5V AAA battery.
20 100 1K
Frequency in Hz
Fig. 2
3.409"
(8.7 CM)
3.129"
(7.9 CM)
.732"
(1.86 cm)
10K 20K
.607"
(1.5 cm)
Produktspecifikationer
| Varumärke: | Akg |
| Kategori: | mikrofon |
| Modell: | PZM-185 |
Behöver du hjälp?
Om du behöver hjälp med Akg PZM-185 ställ en fråga nedan och andra användare kommer att svara dig
mikrofon Akg Manualer
17 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
16 September 2025
mikrofon Manualer
- Roland
- Ibanez
- CAD Audio
- DB Technologies
- Schertler
- Mount-It!
- SmallRig
- Plantronics
- Revolabs
- MKC
- American DJ
- Lectrosonics
- Wharfedale
- Connect IT
- Gemini
Nyaste mikrofon Manualer
19 Oktober 2025
19 Oktober 2025
18 Oktober 2025
18 Oktober 2025
18 Oktober 2025
18 Oktober 2025
18 Oktober 2025
16 Oktober 2025
15 Oktober 2025
13 Oktober 2025