AXESS AX-ADXSVI-CH3 Bruksanvisning
AXESS
Inte kategoriserad
AX-ADXSVI-CH3
Läs gratis den bruksanvisning för AXESS AX-ADXSVI-CH3 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 12 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 6.5 recensioner. Har du en fråga om AXESS AX-ADXSVI-CH3 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
AX-ADXSVI-CH3 AX-ADXSVI-CH3
REV. 8/28/17 REV. 8/28/17© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com Integrate • AxxessInterfaces.com
INSTALLATION I NSTRUCTION SINSTALLATION I NSTRUCTION S
Dodge/RAM accessory and NAV output CAN harness 2013-up
• Provides accessory (12 volt 10 amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems or when replacing amplified system
• Provides NAV outputs (parking brake, reverse, and V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• Retains back-up camera (if through the OE radio)
• Retains the use of the 3.5mm AUX jack
• High level speaker input
• USB updatable
Note:
This harness must be used along with the AX-ADXSVI
DODGE
Dart
(small screen option) 2013-2016
RAM
1500, 2500, 3500
(small screen option) 2013-up
Chassis cab 3500, 4500, 5500
(small screen option) 2013-up
APPLICATIONS
WIRING THE AX-ADXSVI-CH3
• Connect the Yellow wire to the radio’s 12 volt battery or memory wire.
• Connect the wire to the radio’s ground wire.Black
• Connect the wire to the ignition wire of the aftermarket radio.Red
• Connect the wire to the illumination wire of the aftermarket radio. If the Orange
aftermarket radio has no illumination wire, tape off the wire.Orange
•
Connect the wire to the left front positive speaker output of the aftermarket radioWhite
.
• Connect the wire to the left front negative speaker output of the aftermarket radio.White/Black
• Tape off and disregard the following (1) wire, will not be used in this application:
Blue/White labeled "500L amp turn on"
• Connect the wire to the right front positive speaker output of the aftermarket radio.Gray
•
Connect the Gray/Black wire to the right front negative speaker output of the aftermarket radio
.
• Connect the wire to the radio’s left rear positive speaker output.Green
• Connect the wire to the radio’s left rear negative speaker output.Green/Black
• Connect the wire to the radio’s right rear positive speaker output.Purple
• Connect the wire to the radio’s right rear negative speaker output.Purple/Black
The following wires are for the aftermarket radios that have navigation built in.
• Connect the wire to the parking brake wire of the aftermarket navigation radio (if applicable).Light Green
•
Connect the wire to the VSS or speed sense wire of the aftermarket navigation radio (if applicable).Blue/Pink
• Connect the wire to the reverse wire of the aftermarket navigation radio (if applicable).Green/Purple
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to test the radio.
•
Tape off and disregard the following (1) wire, will not be used in this application:
Blue/White
labeled "500L amp turn on".
RCA CONNECTIONS
•
Connect the Yellow RCA to the "video in" of the aftermarket radio to retain the OE back up camera (if equipped).
• Connect the and RCA to the audio "AUX in" of the aftermarket radio to retain the OE 3.5mm jack White Red
(if equipped).
ASWC-1 (IF INSTALLING)
After the XSVI is initialized, plug in the ASWC-1 into the 12-pin harness of the AX-ADXSVI-CH3
and refer to the
ASWC-1 instructions.
K PNOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and spected re
mobile elect nics school in our industry.ro
Log onto www.installerinstitute.com or call
800-354-6782 for mo information and take steps re
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
CAUTION!
All accessories, switches, climate controls
panels, and especially air bag indicator lights must
be connected before cycling the ignition. Also, do
not remove the factory radio with the key in the on
position, or while the vehicle is running.
Produktspecifikationer
| Varumärke: | AXESS |
| Kategori: | Inte kategoriserad |
| Modell: | AX-ADXSVI-CH3 |
Behöver du hjälp?
Om du behöver hjälp med AXESS AX-ADXSVI-CH3 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad AXESS Manualer
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
26 Februari 2025
Inte kategoriserad Manualer
- Boehringer Ingelheim
- Metalux
- Estella
- Frient
- Sebo
- Louroe Electronics
- Helight
- Megarevo
- Friedland
- Mr Coffee
- Juwel
- Draper
- Dynamic
- Studio Titan
- Epson
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025