Axxess ASWC-TOY-LEX Bruksanvisning

Axxess Inte kategoriserad ASWC-TOY-LEX

Läs gratis den bruksanvisning för Axxess ASWC-TOY-LEX (8 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 15 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 8 recensioner. Har du en fråga om Axxess ASWC-TOY-LEX eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/8

INSTALLATION INSTRUCTIONS FOR PART ASWC-TOY-LEX

REV. 1/2/2014 INSTASWC-TOY-LEX

CAUTION: Metra recommends disconnecting the

negative battery terminal before beginning any

installation. All accessories, switches, and especially

air bag indicator lights must be plugged in before

reconnecting the battery or cycling the ignition.

NOTE: Refer to the instructions included with the

aftermarket radio.

• OneInterfacedoesitall-Noadditionalinterfacesneeded

• Automaticallyprogramsthebuttonsonthesteeringwheel

• Autodetectswhatradioit’sconnectedto

• Workswithallmajorradiobrands

• USBupdatable

• Allconnectionsaremadebehindtheradio

• Non-volatilememoryretainssettingsevenifbatteryisdisconnectedorinterfaceis

removedfromthevehicle

KIT FEATURES

•Cuttingtool•Crimpingtool•Tape•Connectors

(example:butt-connectors,bellcaps,etc.)

TOOLS REQUIRED

Axxess Steering Wheel Control interface

for select Toyota and Lexus vehicles

APPLICATIONS

See inside front cover

•ASWC-TOY-LEXinterface•12-pinharnesswith

male3.5mmto12and6-pinharness•Female

3.5mmconnectorwithBrownandBrown/White

wires•12kohmresistor

INTERFACE COMPONENTS

ASWC-TOY-LEX

Applications

TOYOTA

Avalon 2003-2004

Prius 2001-2003

Sienna 1999-2003

LEXUS

GS300 1998-2005

GS430 2001-2005

LX470 2001-2002

SC430 2002-2009

Into vehicle

1) Connectthe wireoftheASWC-TOY-LEXtoground. mayusethesameBlack You

groundingpointastheaftermarketradio.

2) Connectthe wireoftheASWC-TOY-LEXtoa12voltaccessorywire,onethatturnsRed

onandoffwiththeignitionkey.

3) Dependingonthevehicleyouareinconnecteitherthe6-pinor12-pinconnectortothe

matingvehicleharness.

To radio

1) theradiosbelow,plugtheincludedfemale3.5mmconnectorwiththe and For Brown

Brown/Whitewiresintothemale3.5mmconnectoroftheASWC-TOY-LEXharness.

• ConnecttheEclipsesteeringwheelcontrolwires(normallyFor Eclipse radios:

Brown Brown/Black Brown Brown/White and )tothe and wiresofthe

ASWC-TOY-LEX.BrownoftheASWC-TOY-LEXgoestothe oftheBrown/Black

Eclipseand oftheASWC-TOY-LEXgoestothe oftheEclipse.Brown/White Brown

• ConnecttheSWCKey1wire tothe wireoftheFor Metra OE: (Grey) Brown

ASWC-TOY-LEX.Isolateandtapethe wire,itwillnotbeused.Brown/White

• For Kenwood or select JVC’s Blue/Yellowwitha steeringwheelcontrolwire:

ConnecttheKenwood/JVCsteeringwheelcontrolwiretothe wireoftheBrown

ASWC-TOY-LEX.Isolateandtapethe wire,itwillnotbeused.Brown/White

Installation

Table of Contents

Installation

– Intovehicle............................................................................................2

– Toradio.............................................................................................. 2-3

Programming...........................................................................................3

Troubleshooting.......................................................................................3

Manually changing radio.........................................................................4

– Radiolegend..........................................................................................4

Remapping the SWC buttons..................................................................5

– Buttonassignmentlegend......................................................................5

– ResettingtheSWCbuttonsbacktodefault.............................................5

ASWC-TOY-LEX

Installation

Note: Some of the newer Kenwood radios will auto detect as a JVC. If this is

the case, use the included 12k ohm resistor in line between the Blue/Yellow

and Brown wire of the female 3.5mm jack during programming only (remove

resistor once programmed). Or you can manually set the radio type which is in

the Manually Changing Radio Type section.

2) For Parrot Asteroid Smart or Tablet:ConnecttheASWC-TOY-LEXmale3.5mm

jackintotheAX-SWC-PARROT(soldseparately)female3.5mmjackandplug

the4-pinendintothecorrespondingSWCplugontheradio.

 Note: AX-SWC-PARROT (sold separately) and radio required must be

updated to rev 2.1.4 or higher.

3) Pluginthemale3.5mmconnectoroftheASWC-TOY-LEXFor all other radios:

intothebackoftheaftermarketradio,designatedforanexternalsteeringwheel

controlinterface.Pleaserefertotheaftermarketradiosmanualifyouarein

doubtwherethe3.5mmconnectoroftheASWC-TOY-LEXgoes.

4) Onceallconnectionshavebeenmade,plugintheaftermarketradioifnot

donealready.

2) Oncesolid,theASWC-TOY-LEXshouldbeworking.

Note: The ASWC-TOY-LEX will give you two sets of LED feedback reports. The

first set of flashing green LED lights is for knowing the vehicle type and the

second set of red flashing LED lights is for knowing the radio type. Knowing the

vehicle type is irrelevant as this interface is pre-programmed for vehicles in the

application list only. But knowing the radio type is important for troubleshooting

if the ASWC-TOY-LEX does not work. Please see the below Radio Legend for

LED feedback information for radio type.

Programming

Troubleshooting

1) Confirmthatthe3.5mmconnectorisconnectedtoyourradiosecurely inand

thecorrectlocation.

2) Ifusingthefemale3.5mmconnectorinEclipse,Kenwood,selectJVC,orMetra

OEradios,verifythattheradio’ssteeringwheelcontrolwireisconnectedtothe

correctwiretotheASWC-TOY-LEX.

Note: Not every radio will have all the possible SWC commands on the steering

wheel. Please refer to the radio owner’s manual or contact the radio vendor for

specific commands that the radio will recognize.

TheASWC-TOY-LEXwillautoprogramitselfthroughAutoDetectMode.

1) TurntheignitiononandwaituntiltheLEDontheASWC-TOY-LEXgoessolid

(abouttwentyseconds).

Note:Do not press any buttons on the steering wheel or radio during this time.

Programming

Produktspecifikationer

Varumärke:	Axxess
Kategori:	Inte kategoriserad
Modell:	ASWC-TOY-LEX

Behöver du hjälp?

Om du behöver hjälp med Axxess ASWC-TOY-LEX ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

Inte kategoriserad Axxess Manualer

Axxess AX-MLOC-HD1 Bruksanvisning

26 September 2024

Axxess AXI-RGB1 Bruksanvisning

19 September 2024

Axxess AFSI-01 Bruksanvisning

19 September 2024

Axxess GMRSAV Bruksanvisning

19 September 2024

Axxess LC-BMRC-01 Bruksanvisning

19 September 2024

Axxess AX-TOYCAM3 Bruksanvisning

19 September 2024

Axxess AX-MITSUCAM Bruksanvisning

19 September 2024

Axxess AX-TOYRSAV Bruksanvisning

19 September 2024

Axxess HDCC-02 Bruksanvisning

19 September 2024

Axxess AX-TOYCAM2 Bruksanvisning

19 September 2024

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer

Planet PWR-240-48 Bruksanvisning

9 April 2025

CaterChef 445001 Bruksanvisning

9 April 2025

Daikin EKWCTRDI1V3 Bruksanvisning

9 April 2025

Simplified MFG SP18CAT120 Bruksanvisning

9 April 2025

AudioQuest Pegasus Bruksanvisning

9 April 2025

Reolink P330 Bruksanvisning

9 April 2025

Reolink NVS16-8MB8 Bruksanvisning

9 April 2025

Drive Medical RTL12045 Bruksanvisning

9 April 2025

Kern MBC-A05 Bruksanvisning

9 April 2025

Daikin EKEXVA250 Bruksanvisning

9 April 2025