Chamberlain C610C Bruksanvisning
Läs gratis den bruksanvisning för Chamberlain C610C (88 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 1.5 recensioner. Har du en fråga om Chamberlain C610C eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/88
TO WATCH VIDEOS GO TO:
tinyurl.com/lgh5x3h
Contents
Owner’s Manual
C610C
Chain Drive
Garage Door Opener
FOR RESIDENTIAL USE ONLY
PRE-PROGRAMMED REMOTE CONTROL
INCLUDED
www.chamberlain.com
www.mychamberlain.com
• Please read this manual and the enclosed safety materials carefully!
• Fasten the manual near the garage door after installation.
• The door WILL NOT CLOSE unless the Protector System
®
is connected
and properly aligned.
• Periodic checks of the garage door opener are required to ensure
safe operation.
• The model number label is located on the front panel of your garage
door opener.
• This garage door opener is compatible with MyQ® and
Security+b2.0® accessories.
• DO NOT install on a one-piece door if using devices or features
providing unattended close. Unattended devices and features are
to be used ONLY with sectional doors.
Garage Opener
Preparation ...................................... 2-5
Assembly .......................................6-10
Installation ..................................11-28
Install the Door Control ............21-22
Install the Protector System® ....23-26
Connect Power .........................27-28
Adjustments .................................29-31
Operation .....................................32-36
Features .......................................33
Using your Garage Door Opener .....34
Motion Detecting Control Panel .....34
Remote Control and
Keyless Entry ................................35
Homelink® ...................................36
To Erase the Memory .....................36
To Open the Door Manually ...........37
Maintenance .....................................38
Troubleshooting ........................... 39-40
Accessories ........................................ 41
Warranty ........................................... 42
Repair Parts .................................43-44
2
Safety Symbol and Signal Word Review
This garage door opener hasbeen designed and tested to offer safe service provided it isinstalled,
operated, maintained and tested in strictaccordance with the instructions and warnings contained in
thismanual.
Mechanical
Electrical
When you see these Safety Symbols and Signal
Words on the following pages,they will alert you to
the possibility ofserious injury or death ifyou do
not complywith the warningsthat accompany
them. The hazard may come from something
mechanical or from electricshock. Read the
warningscarefully.
When you see thisSignal Word on the following
pages, it will alert you to the possibilityof damage
to your garage door and/or the garage door
opener if you do notcomplywith the cautionary
statements thataccompanyit.Read them carefully.
WARNING: This product can expose you to chemicalsincluding lead, which are known to the
State of California to cause cancer or birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov
Unattended Operation
The Timer-to-Close (TTC) feature, the MyQ
®
Smartphone Control app,and MyQ
®
Garage Door and
Gate Monitor are examples of unattended close and are to be used ONLY with sectional doors. Any
device or feature that allows the door to close withoutbeing in the line of sight ofthe door is considered
unattended close.The Timer-to-Close (TTC) feature, the MyQ
®
Smartphone Control, and anyother
MyQ
®
devicesare to be used ONLY with sectional doors.
Check the Door
To preventpossible SERIOUSINJURYor DEATH:
l ALWAYS call a trained door systems technician if garage door binds, sticks, or isout of balance.
An unbalanced garage door may NOT reverse when required.
l NEVER tryto loosen, move or adjust garage door,door springs, cables, pulleys, brackets or
their hardware, ALLof which are under EXTREME tension.
l Disable ALLlocksand remove ALLropes connected to garage door BEFORE installation and
operating garage door opener to avoid entanglement.
l DO NOT install on a one-piece door if using devices or features providing unattended close.
Unattended devices and features are to be used ONLY with sectional doors.
To preventdamage to garage door and opener:
l ALWAYS disable locksBEFORE installing and operating the opener.
l ONLY operate garage door opener at 120V,60Hz to avoid malfunction and damage.
Before you begin:
1. Disable locks and remove any ropes connected to the garage door.
2. Lift the door halfway up. Release the door. Ifbalanced,it should stay in
place, supported entirely by its springs.
3. Raise and lower the door to check for binding or sticking. If your door
binds, sticks, or is out of balance, call a trained door systems
technician.
4. Check the seal on the bottom ofthe door.Anygap between the floor
and the bottom ofthe door must not exceed 1/4 inch (6 mm).
Otherwise, the safetyreversal system may notwork properly.
5. The opener should be installed above the center of the door.Ifthere is
a torsion spring or center bearing plate in the way ofthe header
bracket, itmaybe installed within 4feet (1.2 m) to the left or rightof the
door center.See page 12.
Torsion
Spring
Extension
Spring
OR
Preparation
3
Additional Items You May Need:
Surveyyour garage area to see ifyou will need any of the following items:
n (2) 2X4 PIECES OF WOOD
Maybe used to fasten the header bracket to the structural supports. Also used to position the
garage door opener during installation and for testing the safetyreversing sensors.
n SUPPORTBRACKET AND FASTENING HARDWARE
Mustbe used if you have a finished ceiling in your garage.
n EXTENSION BRACKETS (MODEL 041A5281-1) OR WOOD BLOCKS
Depending upon garage construction, extension brackets or wood blocks may be needed to
install the safetyreversing sensor.
n FASTENING HARDWARE
Alternate floor mounting of the safetyreversing sensor will require hardware not provided.
n DOOR REINFORCEMENT
Required if you have a lightweight steel, aluminum,fiberglassor glasspanel door.
n RAIL EXTENSION KIT
Required if your garage door is more than 7 feet (2.13 m) high.
Tools Needed
3/16
7/16
1/2
5/32
5/16
5/8
9/16
1/4
7/16
Preparation
Produktspecifikationer
| Varumärke: | Chamberlain |
| Kategori: | Inte kategoriserad |
| Modell: | C610C |
Behöver du hjälp?
Om du behöver hjälp med Chamberlain C610C ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Chamberlain Manualer
2 Januari 2025
17 Oktober 2024
8 Oktober 2024
7 Oktober 2024
2 Oktober 2024
2 Oktober 2024
1 Oktober 2024
27 September 2024
23 September 2024
23 September 2024
Inte kategoriserad Manualer
- Woods
- Tele Vue
- Uniprodo
- URC
- Shark
- Lervia
- SEIKI
- Dnipro
- Zipper
- Hazet
- Naturn Living
- Wiko
- Duro
- Ravensburger
- Wonky Monkey
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025