CRUX RVCCH-75R Bruksanvisning


Sidor 3 Engels Inte kategoriserad

Läs bruksanvisningen för CRUX RVCCH-75R gratis online eller ladda ner PDF:en. 17 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga

RVCCH-75R
Rear View with VIM Integration Interface and
Tailgate Handle Camera for RAM Trucks
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0922201 of 3
• Acvates Mygig radio for enabling video features
• Tailgate handle camera included
• Interface includes Audio / Video Input to connect an extra A/V source
• Automacally switches to Rear-view when car is in Reverse mode
• Supports vehicles with manual transmission but does not supply +12V Reverse Trigger. Camera power
must be tapped from the +12V reverse light wire instead
• Plug & Play Installaon
PRODUCT FEATURES:
PARTS INCLUDED:
RVCCH-75R ModuleRVCCH-75R HarnessTailgate Handle Camera
INSTALLATION DIAGRAM:
WHITE Wire
Parking Guideline
DP
ON
DIP
SWITCH
LED
LED RED = Power ON Status
LED BLUE = Data Bus ON Status
Regulator
20 Ft. Coax Cable
8-Pin Molex
TO RADIO
WHITE
22-PIN
(MALE)
GRAY
22-PIN
(MALE)
WHITE
22-PIN
(FEMALE)
GRAY
22-PIN
(FEMALE)
TO FACTORY
HARNESS
Tap Green wire to +12V ACC for non
permanent VIM. Set DIP 1 to OFF.
(toggle switch not included)
WHITE Wire*
(Camera Power Output
+12V 250mA)
RED Wire
Tape O
(Not Used)
*Note that the white wire does not supply Reverse Trigger on Manual
Transmission and should be insulated .Camera power must be connected
to factory reverse light wire instead.
To Source Ground
(ground wire)
(not chassis ground)
A/V OUT
A/V INPUT
To +12V ACC

Betygsätt denna manual


Produktspecifikationer

Varumärke: CRUX
Kategori: Inte kategoriserad
Modell: RVCCH-75R

Behöver du hjälp?

Om du behöver hjälp med CRUX RVCCH-75R ställ en fråga nedan och andra användare kommer att svara dig