DPW Design AV2 Bruksanvisning


Läs gratis den bruksanvisning för DPW Design AV2 (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 26 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 13.5 recensioner. Har du en fråga om DPW Design AV2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/4
AV2
Attenuverter
The base-function of the AV2 is a dual attenuverter. To the two attenuverters a mixer with an
attenuverter on the output and a comparator is connected.
The combination of simple functions makes this a very useful module to have in your toolbox.
The unit can be used as a utility module for control voltages or to run audio through. It is DC
coupled.
Input A and B
When nothing is connected to A or B the input of the attenuverter is
normalled to +5V.
This gives the possibility to set the output from -5V to +5V DC out via the
knob.
When something is connected to A or B that signal can be attenuated or inverted and attenuated
via the knob. In the middle position the output is zero. Max clockwise you get 1 times amplification
through the module and any signal passes through unaffected. Max counter clockwise the
amplification is -1 times. That is 180 degrees out of phase with the input.
The LEDs shows the output voltage. Green is positive and red is negative voltage.
SUM
SUM is the sum of A and B after their attenuverters.
The knob on SUM is an attenuverter as on A and B.
The LED shows the output voltage. Green is positive and red is negative voltage.
DPW Design, Häradsvägen 200, 14171 Segeltorp, Sweden
www.dpw.se MAN-AV2 Rev B


Produktspecifikationer

Varumärke: DPW Design
Kategori: Inte kategoriserad
Modell: AV2

Behöver du hjälp?

Om du behöver hjälp med DPW Design AV2 ställ en fråga nedan och andra användare kommer att svara dig