Honeywell CT87K1004/U1 Bruksanvisning

Honeywell Termostat CT87K1004/U1

Läs gratis den bruksanvisning för Honeywell CT87K1004/U1 (16 sidor) i kategorin Termostat. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 3.7 stjärnor baserat på 3.5 recensioner. Har du en fråga om Honeywell CT87K1004/U1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/16

Owner’s Manual

English: Page 1

Mode d’emploi

Français: Page 6

Manual de Uso

Español: Página 11

T87N Easy-To-SeeTM

The Round®

•

The Round® Easy-To-SeeT M

69-1840EFS-07

Check package contents:

• Thermostat

• Wall anchors & screws (2 each)

• Owner's Manual

• Large Print Subbase Switch Labels

• Coverplate

Before you begin, make sure

you have:

• No. 2 Phillips & small pocket

screwdrivers

• Hammer

• Level (optional)

• Pencil

• Drill and bit (3/16” for drywall, 7/32”

for plaster)

MERCURY NOTICE

If this product is replacing a control that contains mercury in a sealed tube, do not

place the old control in the trash. Contact your local waste management authority for

instructions regarding recycling and proper disposal.

CAUTION: ELECTRICAL HAZARD

Can cause electrical shock or equipment damage. Disconnect power before

beginning installation.

Must be installed by a trained, experienced technician

Read these instructions carefully. Failure to follow these instructions

can damage the product or cause a hazardous condition.

Pre-installation checklist

This thermostat contains a Lithium battery which may contain Perchlorate material.

Perchlorate Material—special handling may apply,

See www.dtsc.ca.gov/hazardouswaste/perchlorate

Read before installing

T87N, T87N1026

T87N Easy-To-SeeTM • Owner's Manual

69-1840EFS—07 2

System Types

• Gas, oil, or electric heat with air

conditioning

• Warm air, hot water, high-efficiency

furnaces, heat pumps, steam, gravity

• Heat only

• Heat only with fan

• Cool only

System Settings

• Heat, Off, Cool

Fan Settings

• Auto, On

Specifications

Temperature Range

• 40° to 90°F (4.5° to 32°C)

Shipping Temperature

• 20° to 120°F (28.9° to 48.9°C)

Operating Relative Humidity

• 5% to 90% (non-condensing)

Electrical Ratings

• Voltage: 2030 VAC

• Running current:0.021.0 A,

50/60 Hz

Install the thermostat about 5 feet (1.5 m) above the floor in an

area with good air circulation at average temperature.

Do not install in locations where the thermostat can be affected by:

• Drafts or dead spots behind doors and in corners

• Hot or cold air from ducts

• Sunlight or radiant heat from appliances

• Concealed pipes or chimneys

• Unheated/uncooled areas such as an outside wall behind the

thermostat

NO NO

Installation tips

Product application

This thermostat provides electronic control of 24 VAC single-stage heating

and cooling systems.

English: Français: Español:Page 1 • Page 6 • Página 11

3 69-1840EFS—07

1. Pull wires through wire

hole. Position coverplate

on wall, level and mark hole

positions.

2. Drill holes (3/16” for

drywall, 7/32” for plaster)

and tap in supplied wall

anchors.

3. Pull wire through

coverplate and subbase,

position over anchors,

then insert and tighten

mounting screws. Check

level if desired.

4. Apply the large-print labels

to the coverplate, matching

the labels on the subbase.

1. Loosen screw terminals, insert wires

into terminal block, then re-tighten

screws.

2. Push excess wire back into the wall

opening.

3. Plug the wall opening with

nonflammable insulation to prevent

drafts from affecting thermostat

operation.

Terminal Designations

W Heat relay.

Y Compressor contactor.

G Fan relay.

O Heat pump changeover valve

energized in cooling.

Rc Cooling power. Connect to

secondary side of cooling system

transformer.

R Heating power. Connect to

secondary side of heating system

transformer.

B Heat pump changeover valve

energized in heating.

Wiring

NOTES

R & Rc terminals

In single-transformer system, leave metal

jumper in place between R & Rc. Remove

metal jumper if two-transformer system.

Heat pump systems

If wiring to a heat pump, use a small piece of

wire (not supplied) to connect terminals W

and Y.

Wire specifications

Use 18 to 22-gauge thermostat wire.

Shielded cable is not required.

Coverplate

Subbase

Large-print

subbase switch

labels

Subbase and base installation

Produktspecifikationer

Varumärke:	Honeywell
Kategori:	Termostat
Modell:	CT87K1004/U1
Färg på produkten:	Meerkleurig
Ursprungsland:	Indonesië
Antal per paket:	2 stuk(s)
Innehåller inte:	Bisfenol A / BPA
Antal F-boxar i A-box:	6 stuk(s)
Typ produkt:	Drinktuit
Antal ventiler:	2
Ålder (min):	6 maand(en)
Mjukdrickspip:	2 stuk(s)