Jonsbo CR-901 RGB Bruksanvisning


Läs gratis den bruksanvisning för Jonsbo CR-901 RGB (2 sidor) i kategorin kylsystem för dator. Guiden har ansetts hjälpsam av 31 personer och har ett genomsnittsbetyg på 3.9 stjärnor baserat på 16 recensioner. Har du en fråga om Jonsbo CR-901 RGB eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
CR-901
CPU heat sink
hux nut
flat ring gasket
Open wrench
根据需要将螺杆装入INTER对应孔位内,
将隔套内螺母朝上拧紧固定。
Install threaded rod to the corresponding holes of INTEL bracket
将INTER支架安装到散热组上,并用螺丝拧紧。
Place INTEL bracket on the cooler base, and then use bracket
screws to fix it.
将主板孔位对准散热器定位螺丝,反扣于散热组上。
装入绝缘垫片。
Install insulating washers.
Fix the coolers on the motherboard by fixing the hex nuts
with the wrench.
用开口板手拧紧六角螺母,将散热阻固定到主板上。
The board in place, the fan wire connector is
connected with the mainboard .
主板归位后,将风扇导线接头与主板连接。


Produktspecifikationer

Varumärke: Jonsbo
Kategori: kylsystem för dator
Modell: CR-901 RGB

Behöver du hjälp?

Om du behöver hjälp med Jonsbo CR-901 RGB ställ en fråga nedan och andra användare kommer att svara dig