Konig SAS-DUMMYCAM80 Bruksanvisning

Konig övervakningskamera SAS-DUMMYCAM80

Läs gratis den bruksanvisning för Konig SAS-DUMMYCAM80 (51 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 3.6 stjärnor baserat på 5.5 recensioner. Har du en fråga om Konig SAS-DUMMYCAM80 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/51

SAS-DUMMYCAM80

MANUAL (p. 2)

ANLEITUNG (S. 4)

MODE D’EMPLOI (p. 6)

GEBRUIKSAANWIJZING (p. 8)

MANUALE (p. 10)

MANUAL DE USO (p. 12)

MANUAL (p. 14)

HASZNÁLATI ÚTMUTATÓ (o. 16)

KÄYTTÖOHJE (s. 18)

BRUKSANVISNING (s. 20)

NÁVOD K POUŽITÍ (s. 22)

MANUAL DE UTILIZARE (p. 24)

ΕΓΧΕΙΡΙΔΙΟ XPHΣHΣ (σελ. 26)

BRUGERVEJLEDNING (s. 28)

VEILEDNING (s. 30)

ИНСТРУКЦИЯ (32 стр.)

KILAVUZ (s. 34)

KASUTUSJUHEND (lk. 36)

NÁVOD (s. 38)

ROKASGRĀMATA (lpp. 40)

NAUDOJIMO VADOVAS (42 p.)

PRIRUČNIK (str. 44)

РЪКОВОДСТВО (p. 46)

INSTRUKCJA OBSŁUGI (str. 48)

PRIROČNIK (str. 50)

Security Dummy Camera

ENGLISH

Introduction:

CCTV dummy camera in outdoor housing with (fake) IR LED. Professional design for the

impression of security. With built-in ashing LED. Adjustable mounting bracket included.

Placing the batteries:

Open the battery compartment at the back of the camera with a screwdriver. Place 2x AA

1.5V batteries in the battery compartment, ensuring that they conform to the correct polarity

marking inside the battery compartment. After placing the batteries, close the battery

compartment.

Adjusting the angle of the camera/bracket:

The camera/bracket can be adjusted in two ways.

1) Pull back the bracket while holding the camera in one hand. Turn the angle of the

camera/bracket.

2) Loosen the screw in the bracket and adjust the angle. Do not forget to tighten the screw

after the angle is adjusted.

Specications:

• Depth: 27 cm

• Height: 14.5 cm

• Diameter camera: 9.2 cm

• Battery: 2x 1.5 V AA (not included)

• Housing: plastic

• IP protection: IP65

ENGLISH

Maintenance:

Clean only with a dry cloth.

Do not use cleaning solvents or abrasives.

Warranty:

No guarantee or liability can be accepted for any changes and modications of the product or damage caused due to incorrect use

of this product.

General:

Designs and specications are subject to change without notice.

All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognized

as such.

This manual was produced with care. However, no rights can be derived. König Electronic can not accept liability for any errors in this

manual or their consequences.

Keep this manual and packaging for future reference.

Attention:

• This product is marked with this symbol. It means that used electrical and electronic products should not be mixed

with general household waste.

• There is a separate collections system for these products.

This product has been manufactured and supplied in compliance with all relevant regulations and directives, valid for all member

states of the European Union. It also complies to all applicable specications and regulations in the country of sales.

Formal documentation is available upon request. This includes, but is not limited to: Declaration of Conformity (and product

identity), Material Safety Data Sheet, product test report.

Please contact our customer service desk for support:

via website: http://www.nedis.com/en-us/contact/contact-form.htm

via e-mail: service@nedis.com

via telephone: +31 (0)73-5993965 (during oce hours)

NEDIS B.V., De Tweeling 28, 5215 MC ’s-Hertogenbosch, THE NETHERLANDS

Produktspecifikationer

Varumärke:	Konig
Kategori:	övervakningskamera
Modell:	SAS-DUMMYCAM80
LED-indikatorer:	Ja
Certifiering:	UL, CE, FCC, ATEX, UL/cUL
Inspänning:	12 - 48 V
Förvaringstemperatur:	-40 - 85 °C
Våglängd:	1310 nm
Stroomverbruik:	163 mA
Värdgränssnitt:	RS-232
Mått (B x D x H):	30.3 x 70 x 115 mm
Montage:	DIN-rail
Drifttemperatur (TT):	0 - 60 °C
Relativ luftfuktighet i drift (VV):	5 - 95 procent
Fiberoptisk kontakt:	ST
Utgångsgränssnitt:	Vezel (ST)
Överströmsskydd:	Ja
RX-känslighet:	-25 dB
Skydd mot elektrostatisk urladdning (ESD).:	15 kV
Baud hastighet:	921.6 Kbit/s
RS-422-signaler:	RxD+, RxD-, SGND, TxD+, TxD-
RS-485-signaler:	RxD+, RxD-, SGND, TxD+, TxD-
TX-utgång:	-5 dB
Sändningsavstånd (single-mode):	40 km