Kramer KDOCK-1/2/3-HOLDER Bruksanvisning
Kramer
Inte kategoriserad
KDOCK-1/2/3-HOLDER
Läs gratis den bruksanvisning för Kramer KDOCK-1/2/3-HOLDER (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 9 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 5 recensioner. Har du en fråga om Kramer KDOCK-1/2/3-HOLDER eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
www.kramerAV.com
info@kramerel.com
Installation Instructions
MODEL:
KDOCK-1/2/3-HOLDER
KDOCK-4-HOLDER
P/N:
2 9 0 0 - 3 0 1 5 2 2 QS
Rev:
3
SAFETY WARNING
Disconnect the unit from the power supply before opening and servicing
For the latest information products a list Kramer distributors, visit on our and of our
Web site where updates to these installation instructions may be found.
We welcome your questions, comments, and feedback.
2
KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER
Congratulations on purchasing your Kramer KDOCK-1/2/3-HOLDER / KDOCK-4-HOLDER
for safely securing USB-C Hub Multiport Adapters . KDock below or a surfaceon
This document describes how to secure the and the KDOCK-1/2/3-HOLDER
KDOCK-4-HOLDER to a surface.
Installing KDOCK-1/2/3-HOLDER the
KDOCK-1/2/3-HOLDER can be installed either under or above a surface. In this example,
it is installed under a table.
To secure the KDOCK-1/2/3-HOLDER under a table:
1. Insert the KDock device into the clamp, in-between the rubber pads.
2. Insert a washer (supplied) and then a nut (supplied) onto each of the studs and tighten.
3. Check the location under the table where you want to install the device and mark the
location for the two installation screws (supplied).
4. Use the two installation screws to secure the under the table.
KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER is secured under a table.
Installation Instructions
3
Installing KDOCK-4-HOLDER the
KDOCK-4-HOLDER can be installed either under or above a surface. In this example, it is
installed a table. Note that when it is installed under, the ip-up device holder cannot be on
used.
To secure the KDOCK-4-HOLDER a table: on
1. Place the device on the surface, at the correct location. KDock-4
2. Place the over the device. KDOCK-4-HOLDER
3. Insert the four screws and secure the to the table. KDOCK-4-HOLDER
KDOCK-4-HOLDER is secured on a table.
Produktspecifikationer
| Varumärke: | Kramer |
| Kategori: | Inte kategoriserad |
| Modell: | KDOCK-1/2/3-HOLDER |
Behöver du hjälp?
Om du behöver hjälp med Kramer KDOCK-1/2/3-HOLDER ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Kramer Manualer
21 Februari 2025
2 Februari 2025
4 Januari 2025
20 December 2024
20 December 2024
20 December 2024
20 December 2024
20 December 2024
20 December 2024
20 December 2024
Inte kategoriserad Manualer
- WestBend
- Peerless-AV
- Ordo
- Plantiflor
- Inventum
- Roadinger
- Kindermann
- Alpatronix
- Metapace
- Sure Petcare
- Fizzics
- Berg
- P3 International
- Ashly
- Metra
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025