Mission TF-400 Bruksanvisning

Sidor 1 Engels Lampa

Läs bruksanvisningen för Mission TF-400 gratis online eller ladda ner PDF:en. 22 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga

Ladda ner PDF (0.4 MB) Specifikationer

RUBBER GASKET

WORM DRIVE CLAMP

APRON

QUICK-RELEASE CLAMP

Pull screw head away from clamp housing and pull “tail” through

housing. Cinch down clamp to hand-tight. Note: Housing should

be centered onto apron. Repeat clamp installation on opposite side.

Using a nut driver or torque wrench, tighten quick-release clamps

alternately and rmly to 60 in/lbs. of torque. Slide clamp “tail” back

through top of square eyelet.

Slide “tail” of quick-release clamp down through front square eyelet on

apron. Wrap “tail” underneath and around sewer main, then back up

through rear square eyelet.

CLAMP TAIL

Core appropriate sized hole into sewer main (4" core i.d. of 4.60" -

4.90" & 6" core i.d. of 6.60" - 6.90"). After making sure pipe surface

is clean and free of debris, wrap stainless steel apron and gasket

around sewer main, making sure internal ange of gasket is centered

in hole of cored pipe.

Loosen lateral inlet worm drive clamp. Insert lateral pipe into mouth

of inlet until it rests against the internal pipe stop. Tighten lateral inlet

worm drive clamp to 60 in/lbs. of torque.

Mission Rubber Company LLC

1660 Leeson Ln

Corona, CA 92879 USA

toll free

800.854.9991

fax

800.637.4601

missionrubber.com REV. 8/15

Designed to make lateral service connections.

SEWER SADDLE

T-FLEX® Sewer Saddle

INSTALLATION INSTRUCTIONS

Betygsätt denna manual

Produktspecifikationer

Varumärke:	Mission
Kategori:	Lampa
Modell:	TF-400

Behöver du hjälp?

Om du behöver hjälp med Mission TF-400 ställ en fråga nedan och andra användare kommer att svara dig

Mission TF-400 Bruksanvisning

Produktspecifikationer

Behöver du hjälp?

Lampa Mission Manualer

Lampa Manualer

Nyaste Lampa Manualer