Mission TF-600 Bruksanvisning

Mission Lampa TF-600

Läs gratis den bruksanvisning för Mission TF-600 (1 sidor) i kategorin Lampa. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 3.7 stjärnor baserat på 13 recensioner. Har du en fråga om Mission TF-600 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/1
RUBBER GASKET
WORM DRIVE CLAMP
4
3
21
APRON
QUICK-RELEASE CLAMP
Pull screw head away from clamp housing and pull “tail” through
housing. Cinch down clamp to hand-tight. Note: Housing should
be centered onto apron. Repeat clamp installation on opposite side.
Using a nut driver or torque wrench, tighten quick-release clamps
alternately and rmly to 60 in/lbs. of torque. Slide clamp “tail back
through top of square eyelet.
Slide “tail of quick-release clamp down through front square eyelet on
apron. Wrap “tail underneath and around sewer main, then back up
through rear square eyelet.
CLAMP TAIL
Core appropriate sized hole into sewer main (4" core i.d. of 4.60" -
4.90" & 6" core i.d. of 6.60" - 6.90"). After making sure pipe surface
is clean and free of debris, wrap stainless steel apron and gasket
around sewer main, making sure internal ange of gasket is centered
in hole of cored pipe.
Loosen lateral inlet worm drive clamp. Insert lateral pipe into mouth
of inlet until it rests against the internal pipe stop. Tighten lateral inlet
worm drive clamp to 60 in/lbs. of torque.
Mission Rubber Company LLC | 1660 Leeson Ln |Corona, CA 92879 USA
toll free
800.854.9991
fax
800.637.4601
missionrubber.com REV. 8/15
Designed to make lateral service connections.
S E W E R S A D D L E
TF
T-FLEX® Sewer Saddle
I N S T A L L A T I O N I N S T R U C T I O N S

Produktspecifikationer

Varumärke: Mission
Kategori: Lampa
Modell: TF-600

Behöver du hjälp?

Om du behöver hjälp med Mission TF-600 ställ en fråga nedan och andra användare kommer att svara dig