Mosconi Gladen Pro 5/30 Bruksanvisning
Läs gratis den bruksanvisning för Mosconi Gladen Pro 5/30 (1 sidor) i kategorin mottagare. Guiden har ansetts hjälpsam av 19 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 10 recensioner. Har du en fråga om Mosconi Gladen Pro 5/30 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/1
PRO 5|30
4-channel AB class / 1-channel D amplifier [ Rev. 3.0 – 2017/10 ]
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
CEA-2006-A SPECIFICATIONS
POWER RATING :(@ 4 Ohm < 1% THD+N) 70Wx2 + 150Wx2 + 550Wx1
SN RATIO :(ref.: 1 Watt into 4 Ohm) >75 dBA (CH1/2) >71 (CH3/4) >73 (CH5)
SN RATIO Direct DSP :(ref.: 1 Watt into 4 Ohm) >83 dBA (CH1/2) >76 (CH3/4) >76 (CH5)
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MOS SPECIFICATIONS (Tcase = 25 °C / 4 Ohm stereo / 0.2V input level @ 14.4 Volt if not otherwise specified)
TARGET POWER: 85x2 Watt (CH1/2), Watt (CH3/4), Watt (CH5) [@ 4 Ohm]170x2 600x1
REAL POWER ( ):
single section driven CH1/2: W W 95x2 @ 4 Ohm / 150 x2 @ 2 Ohm
1% THD [CH1/2/3/4] – 3% THD [CH5] CH3/4: W W 185x2 @ 4 Ohm / 290 x2 @ 2 Ohm
CH5: W W 660 @ 4 Ohm / 1030 @ 2 Ohm
REAL POWER ( ):
all sections driven 70x2 W (CH1/2) + W (CH3/4) + W (CH5)150x2 @ 4 Ohm 550x1 @ 4 Ohm
1% THD [CH1/2/3/4] – 3% THD [CH5] 65x2 W (CH1/2) + W (CH3/4) + W (CH5)135x2 @ 4 Ohm 760x1 @ 2 Ohm
W (CH1/2) + W (CH3/4) + W (CH5)85x2 195x2 @ 2 Ohm 750x1 @ 2 Ohm
Watt ( )1310 is the total amount of power the amplifier can deliver
THD (90% power rating ref.)
4 Ohm / ST mode < 0.045 % < 0.035 % < 1 % (CH1/2 - 1KHz) (CH3/4 - 1KHz) (CH5 - 100Hz)
2 Ohm / ST mode:< 0.05 % < 0.04 % < 1 % (CH1/2 - 1KHz) (CH3/4 - 1KHz) (CH5 - 100Hz)
DC-DC converter typology / Conversion frequency: Unregulated Push-Pull / 50 Khz (managed by microcontroller)
Supply voltage range operation: 9 V ÷ 16 V 11 V ÷ 14.4 V (Absolute maximum) / (Recommended)
Under / Over Voltage Safety Thresholds: 8 V 16 V(1 sec. 6V sustaining for Start & Stop) /
Mute delay time: 4 secs.
Secondary voltages (VDD#12 /VDD#34 /VDD#5 / DRIVE / SERV): ±33.1 V / ±45.3 V / ±84.7 V / ±14 V / ±15 V
Max output offset voltage (each channel): ±15 mV
Standby current: < 1 mA (typical)
Quiescent consumption @ 12V6 / 14V4: 1.90 A / 2.15 A (no idle current regutation)
Idle current regulation (no signal): 0.05 A (each trimmer)
Quiescent consumption @ 14V4: 2.25 A (with idle current setted)
Thermal protection consumption: 140 mA
Ground decoupling: (RCA Input) / 47R 1 KOhm (battery vs secondary) / (body vs battery)68 Ohm
Bandwidth (-3dB ÷ 1 Watt): < 5 Hz ÷ 135 KHz < 5 Hz ÷ 145 KHz < 5 Hz ÷ 1.75 KHz (CH1/2); (CH3/4); (CH5 10Watt)
Input sensitivity (Power rating ref): 0.35 V ÷ 12 V (5.3 V in DDSP mode) (3.1 V in DDSP mode) [CH1/2/3/4] 0.14 V ÷ 5.9 V [CH5]
Input impedance @ 1 KHz (STEREO input): 15 KOhm / 47 Ohm (LL) (HL)
S/N ratio – Power rating ref: (filter: 10 Hz - 500 KHz ) / (filter: 10 Hz - 22 KHz “A” weighted) 67 dB 94 dB
S/N ratio DDSP – Power rating ref: (filter: 10 Hz - 500 KHz ) / (filter: 10 Hz - 22 KHz “A” weighted) 69 dB 100 dB
Channel separation@ 100Hz / 1KHz / 10KHz – 10 Watt ref: 75 dB / 75 dB / 62 dB
Xover functions (selectable filters): CH1/2= HP: 43 ÷ 500Hz(x1) or 430 ÷ 5000Hz(x10) [12 dB/oct – Q: 0.7]
CH3/4= HP: 50 ÷ 200Hz & LP:(430 ÷ 5000Hz) [12 dB/oct – Q: 0.7]
CH5= LP: 43 ÷ 200Hz [24 dB/oct]
Special features: DDSP - Direct DSP (bypass all the preamplifier circuitry but the differential input interface)
HL/LL - High Level / Low Level selectable input
Controlled via uC – Internally controlled via Atmel Processor
Thermal cutoff Threshold: 90°C / 100°C (CH5 cutoff) (Overall cutoff) / (resume to normal operation)70°C
ProSPEED® Fan Controller Threshold: 50°C / 45°C / 70°C (start) (stop) (max speed)
Damping factor @ 100 Hz 10 Watt ref (Right / Left):- 319/397 318/487 153 [CH1/2] - [CH3/4] - [CH5]
Damping factor @ 1 KHz 10 Watt ref (Right / Left):- 291/375 304/453 101 [CH1/2] - [CH3/4] - [CH5]
Damping factor @ 10 KHz 10 Watt ref (Right / Left): - 178/199 183/219 n.a. [CH1/2] - [CH3/4] - [CH5]
Load drive limitations (*): 2 Ohm / 4 Ohm (Stereo / Bridged)
Suggested fuse: 150 A (Internal)
Size (mm): 500 / 205 / 55
Weight (Kg): 5.4
(*) VERY IMPORTANT NOTE - READ CAREFULLY
4 Ohm ST 8 Ohm BTL or – CONTINUOUS SINEWAVE SIGNAL – pure resistive load or speaker load
2 Ohm ST 4 Ohm BTL or – – pure resistive load or speaker loadMUSICAL SIGNAL
2 Ohm – – pure resistive load or speaker load (only CH5)MUSICAL SIGNAL
All Right Reserved - Features may change without notice -
Produktspecifikationer
| Varumärke: | Mosconi |
| Kategori: | mottagare |
| Modell: | Gladen Pro 5/30 |
Behöver du hjälp?
Om du behöver hjälp med Mosconi Gladen Pro 5/30 ställ en fråga nedan och andra användare kommer att svara dig
mottagare Mosconi Manualer
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
mottagare Manualer
- Golden Age Project
- ETON
- Koda
- Sogo
- Citronic
- Solid State Logic
- DLS
- Vaddio
- Shinybow
- Fosi Audio
- Nedis
- Rotel
- Sunstech
- Quad
- MIPRO
Nyaste mottagare Manualer
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025