PAC RadioPRO 4 Bruksanvisning

Läs gratis den bruksanvisning för PAC RadioPRO 4 (3 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 22 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 5 recensioner. Har du en fråga om PAC RadioPRO 4 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

RP4-GM41

Radio Replacement & Steering Wheel Control Interface

for General Motors Vehicles

Pacic Accessory Corporation

® | Clearwater, Florida 33760 | Ph. 866-931-8021 | support@pac-audio.com

©2015 Pacic Accessory Corporation

www.pac-audio.com

Rev. 012115

C

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The RP4-GM41 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN

v2 44-pin connector radios. Using this interface will retain factory features such as steering wheel controls (SWC) &

Warning Chimes when the original radio is removed. Use of this interface also allows you to program two radio functions

to each SWC button by using short press long press dual command functionality. The RP4-GM41 also provides data bus

driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and

parking brake.

1. Once the radio has been removed, the vehicle settings which are normally selected through the factory radio can be accessed by downloading

and installing the PAC Vehicle Settings program from http://www.pac-audio.com/rmware/RP/index.html. Please make your vehicle

settings selections before removing the factory radio for optimal installation time.

2. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the interface into the

vehicle (see below for setting chart).

3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless you wish to

re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always be restored to default settings

by pressing and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to ash 4 times.

4. The LED will ash whenever a SWC button is pressed.

5. BAADIN22 antenna adapter sold separately

Red / WhiteParking Brake

Output (-)

Purple / WhiteVehicle Speed

Output

BlueNot Used

Blue / WhiteNot Used

Red Accessory Output

(1 amp)

Orange / WhiteIllumination Output

(+)

GreenReverse Output (+)

Interface Connector

Yellow Battery +12v

Black Ground

Blue/WhiteNot Used

White Front L + input

White / BlackFront L - input

Grey Front R + input

Grey / BlackFront R - input

Green Rear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Red/White RCAFactory AUX Jack

Vehicle ConnectorSWC Connector

Pacific Accessory Corporation

Interface Connector

See above chart for

wire color descriptions.

Vehicle Connector

See above chart for

wire color description.

SWC Connection

See above chart for

different radio type

connections

Acc On/

Programming

LED

Programming

Button

WiringSWC Connection

Page 1

Blue/YellowKenwood, Newer

JVC, OEM or

Blaupunkt

3.5mm JackAlpine, JVC,

Clarion, Fusion,

Pioneer, Sony,

Valor, Boyo, Dual,

Lightning Audio,

Visteon or Advent

Produktspecifikationer