PECO SB200-001 Bruksanvisning
Sidor 2 Engels Termostat
Läs bruksanvisningen för PECO SB200-001 gratis online eller ladda ner PDF:en. 31 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga
INSTALLATION & WALK TEST
GENERAL
The SB200-001 is an occupancy sensor designed for
automatic HVAC system control. This sensor provides a
changeover (form C) relay signal output for fan coil controller
to activate/deactivate the operation of fan coil automatically.
This sensor can be wall or corner mounted with 110°, 50 ft
(15m) detection range.
INSTALLATION & WALK TEST
Installation
1. Mount the base of mounting bracket on the selected
position. Route the cable through the access tunnel
of mounting bracket.
2. Open the front cover by loosening the locking screw
at the bottom. Route the cable into the unit and
assemble the mounting bracket with the unit.
Wiring Diagram
NC-COM-NO: Output for ON-
OFF control of fan coil operation.
Dry contact signal.
24 V: Power supply (non-polarity)
4. Replace the front cover and then perform the walk
test.
Walk Test
Apply the power supply to the sensor and wait for about 45
seconds to warm unit up. The LED will blink (long-short)
during warm up period. Ensure the jumper head connectors
of ON and OFF delays are placed on “A” position (shortest
delay). Walk across the detection zones (invisible) at normal
speed. The LED will light whenever the sensor detects the
motion. Note: If any jumper is not properly placed, the LED
will blink.
Ceiling Mount
Wall Mount
©Copyright 2004 PECO, Inc. All Rights Reserved P/N 68737 3220-1386 Rev1 Page 1
Do not install where unit is
exposed to direct sunlight or
directly above strong sourcesof
heat.
Make sure the detection area does
not have any obstruction (plants,
large pieces of furniture, curtains
etc.) which may block the
detection.
INSTALLATION HINTS
3. Connect the cable to the corresponding terminals
according to the following instructions.
DESCRIPTION
Installation Instructions
SB200-001
HVAC Occupancy Sensor
Produktspecifikationer
| Varumärke: | PECO |
| Kategori: | Termostat |
| Modell: | SB200-001 |
Behöver du hjälp?
Om du behöver hjälp med PECO SB200-001 ställ en fråga nedan och andra användare kommer att svara dig
Termostat PECO Manualer
PECO T12532-001 Bruksanvisning PECO TF115-023 Bruksanvisning PECO TF115P-002 Bruksanvisning PECO T8532-001 Bruksanvisning PECO TRF 115-007 Bruksanvisning PECO TB155-046 Bruksanvisning PECO SA200-001 Bruksanvisning PECO T4522-001 Bruksanvisning
Populära i Termostat
Termostat Manualer
Nyaste Termostat Manualer
Vemer Tuo Wi-Fi Batteria Bruksanvisning Vemer Kiros-INT Bruksanvisning Carrier TB-TM Bruksanvisning EBERLE SSR-E 6905 Bruksanvisning Pro1 T701i Bruksanvisning Vimar 32041.C Bruksanvisning EBERLE UTE 4100-Rw Bruksanvisning Vimar 03989 Bruksanvisning EBERLE UTE 3800-U Bruksanvisning Pro1 T621-2 Bruksanvisning