Shadow SH950 Bruksanvisning

Läs gratis den bruksanvisning för Shadow SH950 (1 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 5 recensioner. Har du en fråga om Shadow SH950 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Kupferfolie

Sensor

Fax: (561) 743 0460

eMail: [email protected]

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail:[email protected]

Installation Instruction for Shadow SH 950

Double Side Upright Bass Pickup

Fig. 1Fig. 1

Fig. 2Fig. 2

Content:Content:

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplifier with low impedance input.

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplifier with low impedance input.

3.Install the sensors into the bridge slots.

4.Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5.Connect to appropriate amplifier with instrument cable.

3.Install the sensors into the bridge slots.

4.Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5.Connect to appropriate amplifier with instrument cable.

1.Test fit sensors into the slot between the wing and foot.

Pickup should fit tightly for best output (see fig 1).

1.Test fit sensors into the slot between the wing and foot.

Pickup should fit tightly for best output (see fig 1).

2.If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2.If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.

Produktspecifikationer