StarTech.com HB30A7AME Bruksanvisning

Läs gratis den bruksanvisning för StarTech.com HB30A7AME (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 23 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 3 recensioner. Har du en fråga om StarTech.com HB30A7AME eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: July 3, 2019 1:35 PM

Product Diagram (HB30A7AME)

ComponentFunction

12-Wire Terminal Block

• Used to connect an external DC Power Source

(7~48V DC Input) to the Hub.

2Screw Locks (x 8)

• Used to securely lock a USB Device to the

USB-A Port on the Hub.

• Screw Lock Dimensions: Center to center 19

mm, thread size 4 - 40.

3Power LED

• Green: Indicates that the Hub is receiving

power.

4USB-B Host Port

• Used to connect a Host Computer to the Hub.

• Screw Lock Dimensions: Center to center 24

mm, thread size 4 - 40.

5USB-A Ports (x 7)

• Used to connect USB Devices ( x 7) to the Hub.

• Used to charge connected USB-A Devices.

• USB-A Ports support surge and 15KV ESD

(Electrostatic Discharge) Protection.

7-Port Industrial USB 3.0 (5 Gbps) Hub | USB 3.1 Gen 1 to 7x USB-A | ESD & Surge Protection

3

Requirements

For the latest requirements, please visit www.startech.com/HB30A7AME.

• Phillips Head Screwdriver

• Writing Utensil

• Level

• Mounting Screws (x 2)

Installation

Notes: It is recommended to use an external DC Power Source (+7 - 48V DC)

connected to the 2-Wire Terminal Block to ensure sucient power/current is

delivered to each USB-A Port on the Hub.

Powering the Hub Using the Universal Power Adapter

1. Connect the Universal Power Adapter to the Terminal Block and to a AC

Electrical Outlet.

2. Connect a USB-B to USB Cable (the end will depend on USB Port you are

connecting to) to the USB-B Host Port and to a USB port on the Host Computer.

3. The Host Computer’s Operating System should detect the Hub and automatically

install it.

4. Connect your USB Devices to the USB-A Ports (x 7) on the Hub.

Powering the Hub Using the 2-Wire Terminal Block

1. Remove the Terminal Block Connector Housing from the Terminal Block on the

Hub.

2. Using a small screwdriver (Phillips or Flat Head), loosen the screws on the Terminal

Block Connectors.

3. Connect the Power and Ground Wires from your DC Power Source (+7 - 48V DC)

to the proper Terminal Block Connectors, the terminals are marked on the Hub’s

Casing.

4

5

21

Produktspecifikationer